Isoprene emissions from vegetation have a large effect on atmospheric chemistry and air quality. “Bottom-up” isoprene emission inventories used in atmospheric models are based on limited vegetation information and uncertain land cover data, leading to potentially large errors. Satellite observations of atmospheric formaldehyde (HCHO), a high-yield isoprene oxidation product, provide “top-down” information to evaluate isoprene emission inventories through inverse analyses. Past inverse analyses have however been hampered by uncertainty in the HCHO satellite data, uncertainty in the time- and NO x -dependent yield of HCHO from isoprene oxidation, and coarse resolution of the atmospheric models used for the inversion. Here we demonstrate the ability to use HCHO satellite data from OMI in a high-resolution inversion to constrain isoprene emissions on ecosystem-relevant scales. The inversion uses the adjoint of the GEOS-Chem chemical transport model at 0.25 ∘ × 0.3125 ∘ horizontal resolution to interpret observations over the southeast US in August–September 2013. It takes advantage of concurrent NASA SEAC 4 RS aircraft observations of isoprene and its oxidation products including HCHO to validate the OMI HCHO data over the region, test the GEOS-Chem isoprene oxidation mechanism and NO x environment, and independently evaluate the inversion. This evaluation shows in particular that local model errors in NO x concentrations propagate to biases in inferring isoprene emissions from HCHO data. It is thus essential to correct model NO x biases, which was done here using SEAC 4 RS observations but can be done more generally using satellite NO 2 data concurrently with HCHO. We find in our inversion that isoprene emissions from the widely used MEGAN v2.1 inventory are biased high over the southeast US by 40 % on average, although the broad-scale distributions are correct including maximum emissions in Arkansas/Louisiana and high base emission factors in the oak-covered Ozarks of southeast Missouri. A particularly large discrepancy is in the Edwards Plateau of central Texas where MEGAN v2.1 is too high by a factor of 3, possibly reflecting errors in land cover. The lower isoprene emissions inferred from our inversion, when implemented into GEOS-Chem, decrease surface ozone over the southeast US by 1–3 ppb and decrease the isoprene contribution to organic aerosol from 40 to 20 %.
27 January 2019 in Journal of Geophysical Research: Atmospheres
We use the GEOS‐Chem four‐dimensional variational data assimilation system to estimate emissions of carbon monoxide (CO) and nitrogen oxides (NOx) in November 2009 and July 2010. We assimilated CO retrievals from The Measurements of Pollution In The Troposphere (MOPITT), ozone (O3) retrievals from the Tropospheric Emission Spectrometer (TES) and the Optical Spectrograph and InfraRed Imager System (OSIRIS), and NO2 columns from the Ozone Monitoring Instrument (OMI). By assimilating data for multiple chemical species with the four‐dimensional variational scheme we obtain a consistent chemical state over the assimilation period. The modeled O3 bias was reduced to less than 3.5 ppbv everywhere, relative to independent aircraft O3 data, except in the high‐latitude upper troposphere and lower stratosphere. We found that in November, the CO and NOx emission estimates obtained with the multiple species assimilation were generally comparable to those inferred from assimilating only MOPITT or OMI data, respectively, whereas in July the differences were larger. For the main anthropogenic source regions, the inferred North American and European emissions responded most strongly to the multispecies information in the assimilation. In July, North American and European CO emission estimates differed by 31% and 65% relative to the MOPITT‐only estimates, respectively. We also found large differences for the North American and European NOx emission estimates, which differed by 27% and 16% relative to the OMI‐only estimates, respectively. Our results highlight the potential benefit of exploiting the additional constraints offered by multispecies chemical data assimilation.
Isoprene emissions from vegetation have a large effect on atmospheric chemistry and air quality. Bottom-up isoprene emission inventories used in atmospheric models are based on limited vegetation information and uncertain land cover data, leading to potentially large errors. Satellite observations of atmospheric formaldehyde (HCHO), a high-yield isoprene oxidation product, provide top-down information to evaluate isoprene emission inventories through inverse analyses. Past inverse analyses have however been hampered by uncertainty in the HCHO satellite data, uncertainty in the time- and NOx-dependent yield of HCHO from isoprene oxidation, and coarse resolution of the atmospheric models used for the inversion. Here we demonstrate the ability to use HCHO satellite data from OMI in a high-resolution inversion to constrain isoprene emissions on ecosystem-relevant scales. The inversion uses the adjoint of the GEOS-Chem chemical transport model at 0.25° × 0.3125° horizontal resolution to interpret observations over the southeast US in August–September 2013. It takes advantage of concurrent NASA SEAC4RS aircraft observations of isoprene and its oxidation products including HCHO to validate the OMI HCHO data over the region, test the GEOS-Chem isoprene oxidation mechanism and NOx environment, and independently evaluate the inversion. This evaluation shows in particular that local model errors in NOx concentrations propagate to biases in inferring isoprene emissions from HCHO data. It is thus essential to correct model NOx biases, which was done here using SEAC4RS observations but can be done more generally using satellite NO2 data concurrently with HCHO. We find in our inversion that isoprene emissions from the widely used MEGAN v2.1 inventory are biased high over the southeast US by 40 % on average, although the broad-scale distributions are correct including maximum emissions in Arkansas/Louisiana and high base emission factors in the oak-covered Ozarks of southeast Missouri. A particularly large discrepancy is in the Edwards Plateau of central Texas where MEGAN v2.1 is too high by a factor of 3, possibly reflecting errors in land cover. The lower isoprene emissions inferred from our inversion, when implemented into GEOS-Chem, decrease surface ozone over the southeast US by 1–3 ppb and decrease the isoprene contribution to organic aerosol from 40 to 20 %.
24 November 2019 in Springer Proceedings in Complexity