Recently, 3D printing processes have been used to manufacture metal powder filters with manufacturing complex-shape. In this study, metal powder filters of various shapes were manufactured using the metal extrusion additive manufacturing (MEAM) process, which is used to manufacture three-dimensional structures by extruding a filament consisting of a metal powder and a binder. Firstly, filaments were prepared by appropriately mixing SUS316 powder with sizes ranging from 7.5 µm to 50 µm and a binder. These filaments were extruded at temperatures of 100℃ to 160℃ depending on the type of filament being manufactured, to form three types of cylindrical filter. Specimens were sintered in a high vacuum atmosphere furnace at 850℃ to 1050℃ for 1 hour after debinding. The specimens were analyzed for permeability using a capillary flow porometer, porosity was determined by applying Archimedes’ law and microstructure was observed using SEM.
The development of high-performance metal filters is essential for maintaining ultra-clean environments in semiconductor manufacturing. In this study, cross-sealed honeycomb filters were fabricated using STS316L powder via material extrusion additive manufacturing (MEAM) for semiconductor gas filtration. The effects of filter geometry (4 or 9 channels) and sintering temperature (850°C, 950°C, or 1,050°C) on performance were examined. First, 4-channel and 9-channel filters sintered at the same temperature (950°C) exhibited similar porosities of 50.08% and 50.57%, but the 9-channel filter showed a higher pressure-drop (0.26 bar) and better filtration-efficiency (3.55 LRV) than the 4-channel filter (0.19 bar and 3.25 LRV, respectively). Second, for filters with the same geometry (4-channel) increasing the sintering temperature reduced porosity from 64.52% to 40.33%, while the pressure-drop increased from 0.13 bar to 0.22 bar and filtration-efficiency improved from 2.53 LRV to 3.51 LRV. These findings demonstrate that filter geometry and sintering temperature are key factors governing the trade-off between air permeability, pressure-drop, and filtration efficiency. This work provides insights and data for optimizing MEAM-based high-performance metal powder filter design.
30 September 2025 in Archives of Metallurgy and Materials
Metal powder filters are key components in semiconductor manufacturing equipment that play a critical role in preventing the ingress of impurities and fine particles that may be contained in process gases. With the increasingly advanced development of the semiconductor industry, metal powder filters also require more precise and advanced performance. Therefore, in this study, a filter with a honeycomb structure morphology with crossed top and bottom was fabricated by a material extrusion additive manufacturing (MEAM) process. To achieve this, the prepared pellets were subjected to the MEAM, allowing the creation of filters with complex shapes featuring crossed top and bottom structures. After polishing the surface of the specimen, solvent debinding and thermal debinding were performed to remove the binder. Solvent debinding was performed in n-Heptane for 24 hours, while thermal debinding was performed in an Ar atmosphere at a maximum temperature of 800°C. The debinded specimens were sintered under a high vacuum atmosphere at temperatures of 850°C, 950°C, and 1050°C, respectively. The prepared metal powder filters were examined for filter morphology and microstructure using optical microscopy, and pore properties such as porosity and air permeability were evaluated.