In this communication, a triband AMC-backed microstrip antenna is designed. It is implemented by placing a triband microwave antenna which uses coplanar-waveguide (CPW) over a novel artificial magnetic conductor (AMC) with three zero-phases in the reflection coefficient. The AMC unit cell is composed of three homocentric copper rings. The simulated S-parameters generally corresponds to the performance of original antenna without AMC. The return loss of the frequency range 2.4GHz which can be used for WLAN is enhanced. By adjusting the distance between the antenna and the AMC plane, the performance near 1.8GHz can be optimized.
The spill back effect easily occurs in CMOS image sensors, especially under high exposure conditions, which are common under visible light. This undesirable phenomenon can lead to image lag, which in turn severely degrades image quality. The presence of Si/SiO 2 interface states under the Transfer Gate (TG) increases the probability of Coulomb scattering between the electrons in TG channel and the occupied interface states. As a result, the effect of Coulomb scattering on electron mobility cannot be ignored. Therefore, this article proposes a model of spill back effect related to the energy level distribution of Si/SiO 2 interface states under the TG for the first time. By deducing an expression for the mobility under the effect of Coulomb scattering related to the energy level distributions of interface states, the number of electrons injected to pinned photodiode (PPD) from TG is modeled. Simulations were performed with Gaussian, Exponential and measured U-shaped interface state distributions, the consistency between TCAD simulation results and theoretical model shows that the number of electrons injected to PPD from TG is not a single fixed value but a set of dynamic values changing with the energy level distributions of interface states, moreover, it is at least twice as much as that of no interface states, and the higher the density, the greater the number of electrons.
This paper presents a novel, compact, multi-band wearable antenna with high gain. The antenna adopts a side-fed mode for feeding. At the same time, the antenna consists of a zigzag patch with T-shaped, crescent-shaped, coupled double circular slots and a defective ground structure (DGS). The four working frequency bands of the antenna are in the range of 2.82-2.84GHz, 5.19-5.21GHz, 6.68-6.69GHz and 8.03-8.07GHz. It is this ingenious design that enables the antenna to serve the home, commercial, and medical industries at the 2.8GHz frequency band. The antenna can also be used in the home wireless network, industrial and medical frequency bands at 5.21GHz. At 6.68GHz, the antenna exhibits the characteristics of wider bandwidth, solving the problems of short propagation distance and wireless interference. The antenna plays a role in data transmission at 8.06GHz. The wearable hairpin microstrip antenna proposed in this paper has gradually evolved and optimized from the initial basic structure to a high-performance quad-band antenna. In order to increase the gain, the antenna tried different substrate materials, and finally used ROGERS RO4350 material to increase the gain. Compared with the original material, the gains of the antenna are significantly improved. Through the simulation test, it is found that the antenna can be better applied in the wearable field and play a huge role in human body communication.