9 February 2022 in IEEE Transactions on Power Electronics
This article proposes a novel and robust nonlinear controller for a four-phase interleaved boost converter combined with proton exchange membrane fuel cells. The proposed controller has an inner loop based on a backstepping algorithm, which would transfer the state function of the system to the differential equation of the error variable by using a recursive procedure. The reference current is generated by a supertwisting sliding mode (STSM) algorithm in the outer loop; the sliding surface is defined by the error between the output voltage and reference voltage. The strong robustness and highly dynamic feature of the proposed controller are shown by the performance of the output voltage, source current, and settling time. Besides, the parameters of the proposed controller are tuned and then well optimized using a particle swarm optimization algorithm, and their effectiveness is verified by considering the uncertainty of different operation statuses and the deviations of circuit components. Furthermore, a double-loop STSM controller is chosen for comparison and discussion. The effectiveness of the proposed controller is further evaluated through experimental results obtained with a 500 W fuel cell system based on a real-time hardware-in-the-loop system.
1 November 2021 in International Journal of Hydrogen Energy
11 January 2023 in Renewable Energy
28 April 2025 in IEEE Transactions on Transportation Electrification
To achieve redundancy requirements for transportation electrification, a very commonly used method is to have multiple energy storage sources connected in parallel and feed a common dc bus through dc/dc power converters. The dual-active bridge (DAB) converter, in that respect, is an appealing topology to interface these energy storage elements with the main dc grid due to its simple structure and high efficiency. However, conventional optimum control has limitations in the power sharing control scheme. To address these challenges, this article proposes a data-driven method using the artificial neural network (ANN) to generate the optimal control solutions and achieve desired current sharing among parallel DABs. The design process begins with data generation from extensive DAB simulations. Subsequently, the derived data is processed and clustered, such to map DAB phase shifts with its power output. Then the ANN is used to train a surrogate model to map the power demand and phase shifts. With the aid of ANN model, the small-signal model of the DAB converter is also simplified. Finally, the proposed method is implemented in a three-DAB system. The current sharing performance, efficiency, and the small-signal model have been proved by experiments.
2 June 2025 in IEEE Transactions on Transportation Electrification
This article analyses the steady-state dc offset currents on both sides of the high-frequency transformer in a dual-active bridge (DAB) converter for more-electric aircraft (MEA) applications. These converters are widely used for high-voltage-ratio power transfer between 270 and 28 V dc buses, as well as for bidirectional energy exchange with storage devices. However, mismatched resistances in different commutation paths introduce dc components into the ac current waveforms on both sides of the converter. This effect is further exacerbated on the low-voltage (LV) side due to the high-voltage (HV) ratio, potentially leading to increased losses and performance degradation. To address this issue, this article first developed a comprehensive model through detailed analysis of different operation modes of the DAB converter. Then, using this model, a proportion integration (PI) controller and a moving discretized control set model predictive control (MDCS-MPC) controller have been proposed and designed. A comparison is presented to illustrate the steady-state control performances between both control strategies. Both PI and MDCS-MPC controllers can mitigate the dc offset issue, but it seems MDCS-MPS is with much faster response. These findings have been validated with thorough simulation and experimental studies.
30 December 2024 in IEEE Journal of Emerging and Selected Topics in Power Electronics
This paper develops a mechanism to suppress second-carrier harmonics on a common DC bus fed by multiple dual-active bridge (DAB) converters. A mathematical model of dc-link current harmonic components of a DAB is derived. Using this model, it is found that the magnitude and the phase angle of the second-carrier harmonic are mainly determined by the phase shift ratio of the DAB converter. Based on this conclusion, a harmonic suppression control scheme has been developed to manage the phase shifts in carrier waves of the two converters. To mitigate the impacts of differences in leakage inductances, voltage source types and levels, an enhanced harmonic cancellation scheme has been developed using an extra control loop to coordinate the duty cycles between DABs to achieve entire harmonic cancellation in general cases. The proposed method demonstrates a significant reduction of second-carrier harmonics and has been validated in both simulation and experiment results.