The simulation of heat exchange in the working chamber of the device for measuring emissivity was carried. It was shown that the simulation results coincide well with the experimental results. Established that, with the selected technical parameters, the contribution of the conductive-convective component of heat exchange does not exceed 0.1% of the radiation component, and therefore the measurement can be carried out without vacuuming the working chamber. Found suitable area for measurement of emissivity with unevenness of the heat flux distribution, which does not exceed ± 2%.
1 September 1997 in Journal of Engineering Physics and Thermophysics
For industrial control systems, the advantage of directly measuring the heat flux is that, the controlling the parameters of an object at a temperature, only the consequences of thermal action are recorded. The determination of the heat flux can detect a disturbing effect at the initial stage, predict its state and timely correct the mode of operation of the object. The purpose of the work is to provide control of the heat flux in non-stationary conditions with the use of heat flux sensors and to determine the requirements for industrial measurement equipment. From the theoretical and experimental results follows that the use of a modified sensor always gives a gain in time compared with a standard sensor. For study of non-stationary thermal conditions established requirements for the information-measuring system. Given a practical application example of surface heat flux measurements in non-stationary conditions for the control in the flight conditions of the thermal load on elements of the launch vehicle construction.
The article describes the synchronous thermal analysis cyber-physical system operation principle, structure and information processing methods for the heterogeneous wet materials properties researching. The system allows measuring the wet sample heat capacity and evaporation heat of its moisture. The values of these characteristics are necessary to optimize the drying processes of wet raw materials. The system implements the synchronous thermal analysis principle which consists in simultaneously measuring the sample mass change and heat used to evaporate moisture from it. The cyber-physical system consists of a heat unit that provides the necessary temperature regimes, contains heat flux and temperature sensors, heaters, balances and controllers, and electronic unit for data collecting and processing.