1 January 2016 in AIP Conference Proceedings
The purpose of this study is to reduce the vibration in translational and rotational motion with Dynamic Vibration Absorber. The study is conducted by simulation and experimentally to analyze the vibration from main system without DVA and main system with DVA. The DVA prototype used in experiment consists of an electric motor, disc, unbalance mass, absorber mass, belt, main cantilever, box, beam, and absorber cantilever. The distance ratio (rL) is varied by moving the absorber cantiléver. The range of excitation frequency are from 0 Hz to 30 Hz. The ratio of absorber mass to system mass is 0.05. The simulation method is building block diagram from the state variable equation which is achieved from free body diagram of main system without DVA and main system with DVA. The results show that the simulation result has similarity to the experiment result. The displacement increases by the increasing of the distance between center of gravity of absorber and center of gravity of beam. The optimum reduction of vibration occurred at rL=4.
1 January 2017 in AIP Conference Proceedings
13 July 2018 in AIP Conference Proceedings
Shock absorber is designed to convert the kinetic energy from impact into heat energy that is dissipated. The dissipated energy that is produced by conventional shock absorber is wasted. The aim of this paper is to design the shock absorber that can damp the impact and can harvest energy at the same time. It is called Hydro-Magneto-Electric Regenerative Shock Absorber (HMERSA). This research simulated the HMERSA that applied on a front and rear suspension system of a car. The car speed was varied from 0 km/h to 80 km/h. The phase difference of front and rear suspension’s input were 0° and 90°. The results show that the highest power generated is 165 Watt at car speed of 80 km/h and occurred when the phase difference was 0°.
12 May 2025 in Journal of Dynamics, Monitoring and Diagnostics
Polymer gears are increasingly replacing metal gears in applications with low to medium torque. Traditionally, polymer gears have been manufactured using injection moulding, but additive manufacturing (AM) is becoming increasingly common. Among the different types of polymer gears, nylon gears are particularly popular. However, there is currently very limited understanding of the wear resistance of nylon gears, and of the impact of the manufacturing method on gear wear performance. The aims of this work are (a) to study the wear process of nylon gears made using the conventional injection moulding method and two popularly used AM methods, namely, fused deposition modelling and selective laser sintering, (b) to compare and understand the wear performance by monitoring the evolution of the gear surfaces of the teeth, and (c) to study the effect of wear on the gear dynamics by analysing gearbox vibration signals. This paper presents experimental work, data analysis of the wear processes using moulding and image analysis techniques, as well as the vibration data collected during gear wear tests. It also provides key results and further insights into the wear performance of the tested nylon gears. The information gained in this study is useful for better understanding the degradation process of additively manufactured nylon gears. Conflict of Interest Statement The authors declare no conflicts of interest.