3 September 2019 in International Journal of Aerospace Engineering
A folding wing morphing aircraft should complete the folding and unfolding process of its wings while in flight. Calculating the hinge moments during the morphing process is a critical aspect of a folding wing design. Most previous studies on this problem have adopted steady-state or quasi-steady-state methods, which do not simulate the free-flying morphing process. In this study, we construct an aeroelastic flight simulation platform based on the secondary development of ADAMS software to simulate the flight-folding process of a folding wing aircraft. A flexible multibody dynamic model of the folding wing structure is established in ADAMS using modal neutral files, and the doublet lattice method is developed to generate aerodynamic influence coefficient matrices that are suitable for the flight-folding process. The user subroutine is utilized, aerodynamic loading is realized in ADAMS, and an aeroelastic flight simulation platform of a folding wing aircraft is built. On the basis of this platform, the flight-folding process of the aircraft is simulated, the hinge moments of the folding wings are calculated, and the influences of the folding rate and the aircraft’s center of gravity (c.g.) position on the results are investigated. Results show that the steady-state method is applicable to the slow folding process. For the fast folding process, the steady-state simulation errors of the hinge moments are substantially large, and a transient method is required to simulate the flight-folding process. In addition, the c.g. position considerably affects the hinge moments during the folding process. Given that the c.g. position moves aft, the maximum hinge moments of the inner and outer wings constantly increase.
1 March 2020 in Chinese Journal of Aeronautics
22 February 2022 in International Journal of Aerospace Engineering
A folding wing aircraft can autonomously change its configuration in flight to respond to different flying environments. Hinge moment during morphing process is an important basis for driving mechanism design and structural strength check, and its calculation depends on the simulation of the morphing process. Existing studies mostly use the simplified lifting surface method for aerodynamic modeling. In this paper, the CFD-based simulation method is studied, and the results are compared with those by the lifting surface method. First, the unsteady aerodynamic modeling method of the folding wing based on the CFD method is studied, an effective description method is given to define the wall mesh motion caused by wing folding and aileron deflection, and an unfolding–refolding strategy is proposed to improve the quality of the internal mesh in the case of large folding angles. Then, the CFD aerodynamic model is coupled through a developed coupling calculation program with the flexible multibody structure model for the simulation of a flight-morphing process. The comparison with the results of the lifting surface method shows that hinge moments obtained according to the two aerodynamic models are markedly different. Analysis of the difference shows that airfoil thickness considerably affects aerodynamic loading distributions and hinge moments of folding wing aircraft. The lifting surface method ignores airfoil thickness, which will cause large simulation errors in hinge moments.