The present study documents the successful application of a Reynolds-averaged Navier-Stokes model with conventional turbulence closure to calculate discharge coefficients for submerged flow conditions at ogee-type weirs. The flow pattern downstream of submerged weirs is complex. At low submergence, there is a plunging jet and submerged hydraulic jump. At higher levels of submergence, the jet detaches from downstream of the crest and develops toward the free water surface. The results presented are of particular interest to the hydraulic engineer because they demonstrate that reliable results for the complex flow problem are achieved, but only with the use of a fine computational mesh. It is well known that the results of computational fluid dynamics (CFD) models are strongly mesh dependent, but extensive sensitivity analysis is often time-consuming and costly. Therefore, engineering practice relies on cases that have been tested extensively. For the mesh resolution, the present study recommends a nondimensional number that can be used as a reference for modeling flow over weirs. An important result for hydraulic engineering applications is that the minimum mesh resolution for submerged flows is completely different compared to nonsubmerged flows. The simulations are compared to physical experiments from the literature. With sufficient mesh resolution, an average relative error in capacity of 2% across the simulations is achieved for the finest mesh resolution compared to physical experiments.
Direct discharge measurements during flood events can be challenging from a technical as well as from a safety point of view. Therefore, flood discharges are often estimated by extrapolating a rating curve. Extrapolations far outside the range of the directly measured discharges are common, although the associated errors can be large. In this article, a novel method to determine suitable stage measurement locations and derive rating curves using a hydraulic scale model is presented. A hydraulic scale model for a natural gauging station site is produced with a computer numerical control technique, making a detailed representation of the prototype topography and bathymetry. The site is characterized by a complex geometry, and the results of the scale model study reveal that the current location of stage measurement is not suitable for determining the rating curve for high flows. The scale model is used to identify potential locations for future stage measurements, and a flood rating curve is constructed based on field measurements for low flows and scale model data for high flows. The study shows how hydraulic scale modelling can be used to provide more reliable rating curves for large discharges and evaluate new or existing gauging stations located at sites with challenging measurement conditions.
The accuracy of river flow data is very important for most hydrological studies. Even so, the uncertainty of these data is often neglected. The uncertainty can be significant since the flow is rarely measured directly, but rather indirectly through pre-defined functions of the river stage to discharge relationship or rating-curves. The uncertainty is even more prevalent when the rating curve is extrapolated beyond the available stage-discharge pairs (or gaugings) that form the basis for the rating curve. In an on-going case-study, a hybrid modeling technique is utilized to produce synthetic gaugings for the extrapolation of a rating curve. The control at the gauging-station is at a bed-rock drop where the hydraulic conditions is known to be demanding, especially at high flows. The hybrid modeling is a combination of an original approach to physical modeling and a 3-dimensional Reynolds-averaged Navier-Stokes model of the same geometry. The physical modeling makes use of large-scale computer numerical control (CNC) milling technique in a plastic foam material to provide a high-detail geometry from a point cloud. A combination of survey techniques including terrestrial and aerial laser-scans, sonar and total station point measurements are used to produce the necessary detail in the geometry. This paper describes the on-going research project, and presents temporary results of the hybrid modeling
In vitro maturation of oocytes has been described for several species, but to our knowledge this is the first attempt to mature oocytes from reindeer in vitro. Reindeer are seasonal breeders with their main period of breeding activity starting in the beginning of October. Little knowledge exists about in vivo oocyte maturation, fertilization and development of the early embryonic stages after fertilization. The aim of the present study was to examine whether reindeer oocytes collected out of breeding season could be matured in vitro in conventional medias used for bovine oocytes.