1 January 2022 in Physics of Fluids
Complex in situ behavior of fluids during a retrograde condensation process is experimentally investigated in a miniature sandstone core sample. Two depletion experiments were conducted with various pressure decline rates using a three-component synthetic gas mixture with a dew point of 3610 psi. A state-of-the-art miniature core-flooding system integrated with a high-resolution micro-computed tomography scanner was employed to acquire pore-scale evidence of condensate nucleation, growth, accumulation, and mobilization in a natural porous medium under different depletion conditions. Analysis of pore-scale fluid occupancy maps demonstrates the formation of discrete nuclei of the condensate in pore throats and crevices as the pressure drops slightly below the dew point. The in situ fluid configurations show that a greater pressure drawdown rate significantly increases the condensate growth and accumulation. The results also illustrate the occurrence of condensate-to-gas imbibition displacements, i.e., snap-off and piston-like events, and the consequent trapping of the gas phase in the pore space. As the pore pressure is reduced, the condensate droplets are found to connect to each other through wetting layers, whereas the large gas clusters are continuously fragmented into smaller globules with reduced hydraulic connectivities. This effect was more pronounced in the case of the high depletion rate experiment. Furthermore, the condensate banking was not completely eliminated (through evaporation) by re-injecting the gas phase. This implies that in the development of a gas condensate reservoir, condensate dropout and banking should be minimized in the first place by, for instance, producing at lower pressure drawdown rates.
1 September 2017 in Journal of Environmental Engineering
Electropositive filtration (EPF) uses a macroporous filter media with a strong positive charge to achieve high separation factors for substances many times smaller than its nominal pore size; however, the variables that affect its performance are poorly understood. The objective of this work was to elucidate the significance of filter fouling and particle size in relation to electroadhesion in determining material removal by an electropositive filter. EPF performance was evaluated using humic acid (HA) and montmorillonite clay in adsorption and dead-end filtration experiments. Comparative analyses were done with a negatively charged microglass filter of similar nominal pore size. The electropositive filter had a higher selectivity for HA and clay because of favorable charge–charge interactions. HA and clay removal were governed by aggregate size and filter fouling. For the HA, accumulation of negatively charged material on the electropositive filter resulted in decreased removal as filtration progressed because of screening of the charge interactions. For the clay, rapid fouling resulted in high removal but plugging of the filter. Precoagulation resulted in optimum performance conditions—high selectivity and low headloss development.
1 October 2023 in Physics of Fluids
In this study, state-of-the-art imaging technology is integrated with a miniature core-flooding system to map pore-scale fluid occupancy during the retrograde condensation process in the presence of brine and in a natural porous medium. Two depletion experiments were performed using a three-component synthetic gas condensate mixture in a Fontainebleau sandstone core sample and after establishing different levels of initial water saturations. The results are analyzed to investigate the impact of water saturation on condensate formation, accumulation, and mobilization and to shed light on the relevant three-phase flow dynamics. The results provide the first direct pore-scale observation of gas, condensate, and brine residing in the pore space. The micro-scale fluid occupancy maps illustrated that the presence of water in the pores delays the pressure at which condensate nuclei form, slows down the initial growth of nuclei, and partially impedes the accumulation of condensate. The higher the water saturation is, the lower the amount of condensate will be accumulated. As the pore pressure decreases, the condensate clusters develop significantly in the pore space triggering chains of displacement events between various pairs of fluids. The key mechanisms include gas-to-brine/condensate and condensate-to-gas/brine. The displacement events eventually reduce the brine saturation and increase the gas and condensate saturations in the pore space. The condensate saturation increases monotonically as the pore pressure reduces and reaches a maximum value. Quantitative pore fluid occupancy data also reconfirm the visual observations and demonstrate that condensate accumulation is associated with displacing gas and brine from small- and medium-sized pore elements.