Efficient all-perovskite tandem cells: Organic-inorganic perovskite films can boost the output of conventional silicon solar cells in tandem geometries by utilizing more of the light at the blue end of the solar spectrum. Tandem cells that use only perovskite films have been less successful because of the lack of a suitable material with a low bandgap that can replace silicon. Tong et al. report that a mixed tin-lead organic-inorganic material containing a small fraction of guanidinium thiocyanate has a low bandgap, long charge-carrier lifetime, and efficiencies around 25%. Science , this issue p. 475
18 February 2020 in Energy & Environmental Science
Recent achievements of 2D perovskites for various optoelectronic applications along with their basic properties and future opportunities are discussed.
Engineering perovskites with anions: The bandgap of the perovskite top layer in tandem silicon solar cells must be tuned to ∼1.7 electron volts. Usually, the cation composition is varied because the bromine-rich anion compositions with wide bandgaps are structurally unstable. Kim et al. show that by using phenethylammonium as a two-dimensional additive, along with iodine and thiocyanate, bromine-rich perovskite films can be stabilized. A tandem silicon cell delivered >26% certified power conversion efficiency, and a perovskite device maintained 80% of its initial power conversion efficiency of >20% after 1000 hours under illumination. Science , this issue p. 155
The development of highly stable and efficient wide-bandgap (WBG) perovskite solar cells (PSCs) based on bromine-iodine (Br–I) mixed-halide perovskite (with Br greater than 20%) is critical to create tandem solar cells. However, issues with Br–I phase segregation under solar cell operational conditions (such as light and heat) limit the device voltage and operational stability. This challenge is often exacerbated by the ready defect formation associated with the rapid crystallization of Br-rich perovskite chemistry with antisolvent processes. We combined the rapid Br crystallization with a gentle gas-quench method to prepare highly textured columnar 1.75–electron volt Br–I mixed WBG perovskite films with reduced defect density. With this approach, we obtained 1.75–electron volt WBG PSCs with greater than 20% power conversion efficiency, approximately 1.33-volt open-circuit voltage ( Voc ), and excellent operational stability (less than 5% degradation over 1100 hours of operation under 1.2 sun at 65°C). When further integrated with 1.25–electron volt narrow-bandgap PSC, we obtained a 27.1% efficient, all-perovskite, two-terminal tandem device with a high Voc of 2.2 volts.