23 November 2021 in Frontiers in Earth Science
Marine vertical cable seismic (VCS) is a promising survey technique for submarine complex structure imaging and reservoir monitoring, which uses vertical arrays of hydrophones deployed near the seafloor to record seismic wavefields in a quiet environment. Recently, we developed a new type of distributed VCS system for exploration and development of natural gas hydrates preserved in shallow sediments under the seafloor. Using this system and air-gun sources, we accomplished a 3D VCS yield data acquisition for gas hydrates exploration in the Shenhu area, South China Sea. In view of the characteristics of VCS geometry, we implement reverse time migration (RTM) on a common receiver gather to obtain high-resolution images of marine sediments. Due to the unique acquisition method, it is asymmetrical for the reflection path between the sources and the receivers in the VCS survey. Therefore, we apply accurate velocity analysis to common scatter point (CSP) gathers generated from common receiver gathers instead of the conventional velocity analysis based on common depth point gathers. RTM with this reliable velocity model results in high-resolution images of submarine hydrate-bearing sediments in deep water conditions. The RTM imaging section clearly shows the bottom simulating reflector (BSR) and also the reflection characteristics of the hydrate-bearing sediments filled with consolidated hydrates. Moreover, its resolution is relative to that of acoustic logging curves from the nearby borehole, and this imaging section is well consistent with the synthetic seismogram trace generated by the logging data. All these results reveal that VCS is a great potential technology for exploration and production of marine natural gas hydrates.
18 July 2018 in Geophysics
Geosteering is a key technique to increase oil and gas production rate, especially within a thin reservoir layer. The purpose of geosteering in production zone is to keep the drilling path in oil and gas bearing reservoir. In order to keep the drilling system inside the production zone, downhole sensors must be able to detect bed boundaries, which include identifying the boundary location with respect to the sensor, as well as boundary distance from the sensor. We have developed a directional resistivity logging-while-drilling (LWD) tool for geosteering applications. The directional LWD tool is equipped with a joint-coil antenna composed of an axially polarized coil Rz connected in series with two transversely polarized coils Rx. During a revolution around the axis of the tool, voltage of the axial coil VRz, voltage of the transverse coils VRx and tool face angle ø0, which indicates boundary direction, can be extracted through curve fitting the total voltage response of the joint-coil antenna. The distance to boundary can be derived from a 1D inversion. The LWD tool has been tested in several reservoirs in China and demonstrated capability to provide reliable and accurate estimations to the boundary direction and distance. Field data shows that the boundary detection depth can reach 2.1 m and 1.7 m when the tool is in a sand and shale formation. Utilizing wireline logging data from surrounding wells as reference, deviations between the reference and the measured distance to the boundary are within 0.2 m.