This article proposed an underwater simultaneous wireless power transfer and data transfer system for the autonomous underwater vehicle. The double-sided LLCC compensation topology is proposed to effectively suppress the interference to the data channel at switching instant. With the increase of the size and turns of the coupling coils, the self-resonance frequency gradually decreases. However, the frequency of data carriers is usually much lower than the self-resonant frequency, which will reduce the data rate or improve the bit error rate at a high data rate. Moreover, the high voltage generated by coupling coils causes high voltage stress on the data channel. To deal with these two issues, the last turn of each coupling coil is used to transfer data in the proposed system. The two transceivers are, respectively, connected with the last turn of the two coupling coils, which excites the entire coils to self-resonate and generates two resonant frequencies. The two resonant frequencies are utilized to realize high-speed full-duplex communication. And the voltage stress of the data channel is effectively reduced. A 518-W full-duplex prototype is built, and the maximum data rate is 700 kb/s, which verifies the feasibility of the proposed system.
6 August 2020 in IEEE Transactions on Power Electronics
the capability of misalignment tolerance is vital for an IPT (inductive power transfer) system. The conditions satisfied by the high-misalignment tolerant compensation topology are proposed in the paper. It is proven that all compensation topologies with secondary parallel compensation component have a strong capability of misalignment tolerance if the parameters of the compensation circuit are properly designed. And their misalignment-tolerant capability was analyzed. The impedance characteristics of the simple S/T compensation topology are analyzed. Two prototypes of approximately 300 W used S/SP (primary series, secondary series- parallel) compensation topology with strong misalignment tolerance were designed to verify the system performance. They have the characteristics of CV and CC output, respectively.
3 May 2021 in IEEE Transactions on Industrial Electronics
The capability of misalignment tolerance is vital for an inductive power transfer (IPT) system. In this article, a new loosely coupled transformer (LCT) structure with series solenoid and DD pads (SDDP) is proposed to improve the misalignment tolerance of the IPT system. The designed LCT not only has strong misalignment-tolerant capability in the X -direction but also has strong misalignment-tolerant capability in the Y -direction. The fluctuation of mutual inductance is 3.15% within 67.0% misalignment distance of the largest size of the SDDP in the X -direction and 44% misalignment distance of the largest size of the SDDP in the Y -direction. Finally, an LCC /S compensated IPT system with 300 W power is built as an example to demonstrate the performance of the proposed LCT. The output voltage fluctuates with the rated load, which is less than 3.2%, and the efficiency is 90.2–91.3%.
1 October 2020 in IEEE Transactions on Industrial Informatics
the capability of misalignment tolerance is vital for an IPT (inductive power transfer) system. A new method that design the parameters of series/series-parallel (S/SP) compensation topology with undiscovered strong misalignment- tolerant capability is proposed in this paper. The paper shows the possibility of keeping the output voltage basically constant even with high misalignment if the load is not too heavy and the parameters of the compensation circuit are properly designed. The relationship between primary input impedance angle and secondary input impedance angle with coupling coefficient and load resistance was also analyzed to achieve high efficiency over a wide load range. Then, a 60W prototype with the performance of strong misalignment- tolerant capability was designed to verify the system performance, and it can be used for wireless charging of laptops or other desktop devices.
30 November 2023 in IEEE Transactions on Power Electronics
This letter proposes an undersea simultaneous wireless power and data transfer (SWPDT) system with extended communication distance and 1-Mb/s full-duplex communication. The proposed system operates in inductive power transfer-electric field communication mode, thus reducing the crosstalk between the power channel and communication channel. This letter proposes a novel communication channel construction method based on the single capacitor coupling principle, which can effectively extend the communication distance without additional mechanisms. The extended communication distance enables precommunication before charging and maintaining communication after completing charging, which is critical for undersea dynamic equipment. The resonant condition and transmission characteristics of the communication channel are analyzed. Two MHz communication bands are constructed to achieve full-duplex communication based on frequency division duplexing. Finally, the proposed undersea SWPDT prototype has a maximum output power of 1.2 kW and can maintain 1-Mb/s full-duplex communication within a range of 50 cm.