Homoepitaxial film and semi-insulating bulk β-Ga2O3 with (001) orientation were studied using terahertz time-domain spectroscopy (THz-TDS) in the frequency region from 0.2 to 3.0 THz parallel to the [100] and [010] directions. The static permittivity of the bulk was determined to be 10.0 and 10.4 along the -axis and -axis, respectively, and the refractive index values at 0.2 THz are 3.17 and 3.23 for each axis. The electrical resistivity of the epilayer was extracted with good accuracy by employing the Drude–Lorentz model and without the use of electrical contacts. This noninvasive and contact-free material evaluation through THz-TDS proves to be a powerful tool for probing and obtaining various types of information about β-Ga2O3 materials such as bulk and thin films for the development of β-Ga2O3-based device applications.
The influence of substrate orientation on homoepitaxial growth of beta-gallium oxide by halide vapor phase epitaxy was investigated. Substrates were cut at various angles Δb from the (001) plane (Δb = 0°) to the (010) plane (Δb = 90°) of bulk crystals grown by the edge-defined film-fed growth method. The growth rate increased with increasing absolute value of Δb near the (001). However, from the (001) to the (010), as Δb increased, the growth rate decreased sharply, and streaky grooves observed in the grown layer on the (001) substrate became triangular pits. The length of the pits decreased with increasing Δb, and a pit-free homoepitaxial layer grew at Δb ≈ 60°. The valley line of the pits was parallel to the [010] direction; therefore, the length of the pits decreased with increasing Δb. In addition, transmission electron microscopy observations of the deepest part of a pit revealed that the pits originate from dislocations propagating in the substrate at an angle of 60° with respect to the (001) plane. Therefore, pits are not formed on the grown layer surface when the Δb of the substrate is ∼60°, because its surface is substantially parallel to the dislocations. The homoepitaxial growth of a pit-free layer on the (011) substrate (Δb = 61.7°) was demonstrated, and void defects and dislocations in the substrate were confirmed by the etch-pit method to not be inherited by the homoepitaxial layer.
Homoepitaxial tri-halide vapor-phase epitaxy (THVPE) growth on polar, semipolar, and nonpolar bulk GaN substrates was demonstrated using GaCl3 as the precursor. The influence of the surface orientation of the substrate on GaN growth by THVPE was compared with that observed for GaN grown by hydride vapor-phase epitaxy. The dependence of the GaN growth on the surface orientation of the substrate was confirmed; GaN could be grown on , , , , and but not on , , , or . This behavior was explained to be due to the changes in adsorption energy, the magnitudes of which were estimated by theoretical calculations.