8 September 2018 in Journal of Esthetic and Restorative Dentistry
3 June 2022 in The Journal of Prosthetic Dentistry
29 August 2022 in Odovtos - International Journal of Dental Sciences
This study investigated the shear bond strength (SBS) of a universal adhesive to enamel/dentin; 1) that had undergone radiotherapy (RT) and 2) that were readily restored and had undergone RT. Enamel and dentin surfaces were obtained from 90 intact human molars. They were randomly divided into six groups according to the presence and timing of irradiation (RT0:no radiotherapy/control, RT1:RT before restoration, RT2:RT after restoration groups) and adhesive application modes (etch&rinse/ER, self-etch/SE)(n=15). A universal adhesive and resin composites were applied. The radiotherapy protocol was conducted with 60 Gy. The SBS test was subjected (1mm/min) and failure type analysis was performed. The resin-enamel/dentin interfaces were examined. Data were statistically analyzed. For enamel and dentin, the presence and timing of irradiation did not significantly influence the SBS values (p>0.05). For enamel, significantly higher SBS values were obtained using etch&rinse mode than self-etch mode (p<0.05). The predominant failure was mixed type. Loss of enamel prisms and obliterated irregular dentinal tubules were found for the radiotherapy-treated specimens. Resin tags were clearer in the irradiated enamel treated with ER than SE. Irradiation with different timings did not influence the bond strength to enamel and dentin, negatively. Irrespective of radiotherapy, the etch&rinse mode caused higher bond strength to enamel than self-etch mode.
1 January 2015 in SRM Journal of Research in Dental Sciences
Objectives: The purpose of this study was to evaluate the color change of six esthetic dental composite materials immersed in various solutions for 7 days, and determine the effect of curing time on color change. Materials and Methods: Disk-shaped samples of six types of light curing composite were prepared, and all samples were divided into two groups that were light cured for 20 s and 40 s (n = 7). After 24 h, color measurements were performed with a digital spectrophotometer. Samples were immersed in a solution (coffee, tea, Coke; , cherry juice and distilled water) for 7 days. The discoloration of each specimen was measured and statistically analyzed with a statistics software SPSS Version 17.0 (Released 2008. SPSS Statistics for Windows, Chicago: SPSS Inc.). Results: The discoloration of Filtek™ and Ceram.X was significant. The highest color change values were in Filtek™ group. The lowest color change values were in Herculite classic group. Coffee (ΔE = 12.27) showed the highest influence on color change. There was no effect of curing time on the discoloration of the composites. Significance: The color differences (ΔE) ranged from 3.23 to 12.48. There was no significant difference in color change between two curing times, and coffee was the immersion medium that promoted the highest color change on the tested composite resin.
1 October 2022 in Bezmialem Science