13 April 2015 in Journal of Lightwave Technology
In this paper, a complete theoretical and experimental study of amplitude noise impact on performance of radio-over-fiber (RoF) communication system in millimeter-wave (MMW) frequency band is presented. A simulation method is also presented, using which one can determine the origin of the amplitude noise which has the most impact on error vector magnitude (EVM). This method is based on analyzing the trends of EVM versus received optical power. The impact of different optical and electrical noise such as relative intensity noise, shot noise and thermal noise on EVM is precisely studied employing experimental and theoretical analysis. In the proposed RoF system, two techniques are used to generate MMW signal, and the EVM results are compared from amplitude noise viewpoint. In the first technique, two independent distributed feedback lasers are used to generate MMW signal at the output of a photodetector, and the second technique is based on a passively mode-locked laser diode. Impact of optical sources phase noise on performance of the system is removed using a noncoherent down-conversion method based on envelope detector. Using this method, a very good matching between the experimental and the simulation results is observed.
5 April 2011 in Journal of Lightwave Technology
Simulation and experimental measurements are presented for 60 GHz transmission systems based on upconversion. We demonstrate that chirp in modulated semiconductor lasers combined with upconversion allows to realize a simple system resistant to chromatic dispersion without the need for customized filter. The comparison between two 60 GHz modulation schemes highlights the possibility to reduce power fading, due to chromatic dispersion, to a value as low as optical fiber attenuation.
16 December 2013 in Journal of Optical Communications and Networking
We demonstrate a stabilization and tuning architecture that enables the transmission of a stable modulation sideband in the presence of high carrier instability. The technique can be used in radio-over-fiber (RoF) systems employing optical intensity modulation, and in links featuring optical carrier generation, which might exhibit considerable phase noise or even frequency drift. The stabilization concept is validated experimentally in two systems based on two different laser structures. The results of this paper represent the first demonstration, to our knowledge, of the technique on a RoF system operating in the millimeter-wave range.
1 October 2018 in IEEE Photonics Technology Letters
In this paper, we study and demonstrate, for the first time, how the chromatic dispersion causes laser mode partition noise (LMPN) at millimeter-wave (mm-wave) frequencies. A 60 GHz radio-over-fiber (RoF) transmission system employing an optical frequency comb (OFC) is theoretically and experimentally investigated. Chromatic dispersion is a limiting factor in RoF systems, which induces power fading and phase noise on the resultant mm-wave beating carriers. Furthermore, experimental measurements in this paper show that when transmitting optical comb spectrum across kilometers of optical fiber, chromatic dispersion destroys partition noise compensation between modes. Therefore, the beat note carrier suffers from intensity noise impairments that degrade the system performance.
8 December 2020 in Journal of Lightwave Technology
In this paper, we report on the asymmetry of intensity noise spectrum at millimeter-wave (mm-wave) heterodyne carriers. Passively mode-locked laser diode (PMLLD) is employed for a low phase noise mm-wave photonic generation using direct detection. This optical source produces an excess intensity noise known by laser mode partition noise (LMPN) in which its spectrum usually appears as symmetric double side-bands around the beat-note. The propagation over a dispersive medium such as optical fiber can modify the spectral behavior and profile of the LMPN. This paper explores the impact of fiber transmission on the distortions of the LMPN in optical and electrical spectrum. Experimental results reveal, for the first time, that the LMPN symmetry is converted to an asymmetric deformation on the generated beating carrier. The mathematical model and numerical simulation are presented to give hints for analyzing this phenomenon. The findings of the simulations and measurements demonstrate the main role of second- and thirdorder fiber dispersion on the LMPN profile.