Jisu Yook

Jisu Yook

Auto-generated profile, based on publicly available information

Jisu Yook

System LSI Division, Samsung Electronics, Hwaseong, Gyeonggi, South Korea

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 October 2023 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
Jahoon JinJahoon Jin
Jahoon Jin
SLSoo-Min Lee
Soo-Min Lee
KMKyunghwan Min
Kyunghwan Min
SJSodam Ju
Sodam Ju
JLJihoon Lim
Jihoon Lim
SKSung Ung Kwak
Sung Ung Kwak
This article presents a 16-Gb/s/pin 0.764-pJ/b single-ended four-level pulse-amplitude modulation (PAM-4) transceiver in a 4-nm CMOS process. A switching-jitter compensation technique is proposed in the receiver (RX) to improve timing margins from 0.31 to 0.37 UI at 16 Gb/s, as it adjusts transition slope of the front-end outputs. To compensate for signal-to-noise ratio (SNR) degradation in a PAM-4 signal, relaxed impedance matching is used, where 20 $\Omega$ is used as a transmitter (TX) impedance instead of 50 $\Omega$ . To maximize eye openings further, fractionally spaced feedforward equalization (FS-FFE) is used with a tap spacing of 0.8 UI. The relaxed termination scheme along with FS-FFE improves eye openings by 2.25 times compared with the conventional design using a 50- $\Omega$ TX impedance with 1-UI spacing FFE.

10 October 2024 in IEEE Solid-State Circuits Letters
Verified
Journal Article
Closed access
KMKyunghwan Min
Kyunghwan Min
Jahoon JinJahoon Jin
Jahoon Jin
SLSoo-Min Lee
Soo-Min Lee
SJSodam Ju
Sodam Ju
JYJisu Yook
Jisu Yook
HKHyungjong Ko
Hyungjong Ko
This letter presents a 20 Gb/s/pin single-ended PAM-4 transceiver implemented in an 8nm CMOS process, featuring an advanced switching jitter compensation (SWJC) technique and a DQS-driven amplifier bias generation method for a source-synchronous clocking system, aimed for next-generation low-power memory interfaces utilizing multi-level signaling. The proposed pre-channel SWJC (pre-SWJC) in the transmitter adjusts the input edge timing of the thermometer PAM-4 driver to control the transitions of the PAM-4 signal. This transition control advances the outermost transitions, thereby not only minimizing the switching jitter (SWJ) of the middle eye but also enhancing the effectiveness of the post-channel SWJC (post-SWJC) performed at the receiver. Ultimately, the comprehensive solution combining the proposed pre/post-SWJC improved the timing margin from 0.26 UI to 0.39 UI at a BER of 1e-12, with only a 4.5% increase in power consumption and a 0.59% area overhead. Additionally, the proposed DQS-driven biasing technique in the receiver supplies biases for the amplifiers in the data lanes by utilizing the common-mode feedback of the replica amplifier in the differential clock lane. This approach reduces variation sources compared to the self-biasing structure that uses common-mode feedback in the data lanes, thereby improving the standard deviation of the amplifier’s bias voltage and gain variation by 58.3%.