15 September 2011 in IEEE Transactions on Geoscience and Remote Sensing
In this paper, we investigate the feasibility of uncooperatively and covertly detecting people moving behind walls using passive bistatic WiFi radar at standoff distances. A series of experiments was conducted which involved personnel targets moving inside a building within the coverage area of a WiFi access point. These targets were monitored from outside the building using a 2.4-GHz passive multistatic receiver, and the data were processed offline to yield range and Doppler information. The results presented show the first through-the-wall (TTW) detections of moving personnel using passive WiFi radar. The measured Doppler shifts agree with those predicted by bistatic theory. Further analysis of the data revealed that the system is limited by the signal-to-interference ratio (SIR), and not the signal-to-noise ratio. We have also shown that a new interference suppression technique based on the CLEAN algorithm can improve the SIR by approximately 19 dB. These encouraging initial findings demonstrate the potential for using passive WiFi radar as a low-cost TTW detection sensor with widespread applicability.
15 September 1986 in Physical Review B
The interband photoconductivity of GaAs- As quantum wells has been studied in steady fields of up to 16 T, applied both parallel and perpendicular to the growth axis. In fields parallel to the growth axis, excitonic Landau-level transitions have been identified with Landau indices up to n=12 and energies up to 400 meV above the energy gap of bulk GaAs. Transition energies and diamagnetic shifts have been measured for both allowed (ΔN even) and forbidden (ΔN odd) subband exciton transitions, including a transition at high energy in the widest wells which we tentatively identify as involving a bound state in the spin-orbit split-off band. Landau levels are observed at fields as low as 2.5 T, permitting a determination of exciton binding energy from linear extrapolation. High-field results are fitted using a calculation of the binding energy of two-dimensional excitons as a function of magnetic field. It is found that the exciton binding energy obtained from fitting high-field results is slightly higher than that obtained from low-field measurements, giving exciton binding energies of 16–9 meV, for well widths from 22 to 110 Å. The heavy-hole effective mass for motion in the plane of the layers is found to vary with well thickness, and this is explained by decoupling of the bands.
1 March 1986 in Surface Science
17 May 2018 in IEEE Communications Magazine
Detection and interpretation of human activities have emerged as a challenging healthcare problem in areas such as assisted living and remote monitoring. Besides traditional approaches that rely on wearable devices and camera systems, WiFi-based technologies are evolving as a promising solution for indoor monitoring and activity recognition. This is, in part, due to the pervasive nature of WiFi in residential settings such as homes and care facilities, and the unobtrusive nature of WiFi-based sensing. Advanced signal processing techniques can accurately extract WiFi channel status information (CSI) using commercial off-the-shelf devices or bespoke hardware. This includes phase variations, frequency shifts, and signal levels. In this article, we describe the healthcare application of Doppler shifts in the WiFi CSI caused by human activities that take place in the signal coverage area. The technique is shown to recognize different types of human activities and behavior and be very suitable for applications in healthcare. Three experimental case studies are presented to illustrate the capabilities of WiFi CSI Doppler sensing in assisted living and residential care environments. We also discuss the potential opportunities and practical challenges for realworld scenarios.
15 January 1990 in Physical Review B
We present the first direct measurements of the heavy-hole exciton binding energy in a III-V-compound quantum-well system where the well widths are 25 Å or smaller. The 4-K photoluminescence excitation (PLE) spectrum from As/GaAs multiple-well samples with 48-, 25-, and 14-Å wells displays a sharp heavy-hole exciton feature well resolved from the continuum edge; the separation between these features yields exciton binding energies of 9.2, 8.7, and 6.5 meV, respectively. The decrease in binding energy with decreasing well width confirms the predicted trend from our calculations. Quantitative agreement between the model calculations and the observations is good. In addition, we have seen fine structure in the PLE spectrum of the 14-Å sample in both the heavy- and light-hole excitonic peaks. The energy splitting in the fine structure equates with changes in In fraction of less than 0.5% in 15% or changes in average well width of <1Å.
14 July 2020 in IEEE Transactions on Geoscience and Remote Sensing
Human sensing using WiFi signal transmissions is attracting significant attention for future applications in e-healthcare, security, and the Internet of Things (IoT). The majority of WiFi sensing systems are based around processing of channel state information (CSI) data which originates from commodity WiFi access points (APs) that have been primed to transmit high data-rate signals with high repetition frequencies. However, in reality, WiFi APs do not transmit in such a continuous uninterrupted fashion, especially when there are no users on the communication network. To this end, we have developed a passive WiFi radar system for human sensing which exploits WiFi signals irrespective of whether the WiFi AP is transmitting continuous high data-rate Orthogonal Frequency-Division Multiplexing (OFDM) signals, or periodic WiFi beacon signals while in an idle status (no users on the WiFi network). In a data transmission phase, we employ the standard cross ambiguity function (CAF) processing to extract Doppler information relating to the target, while a modified version is used for lower data-rate signals. In addition, we investigate the utility of an external device that has been developed to stimulate idle WiFi APs to transmit usable signals without requiring any type of user authentication on the WiFi network. In this article, we present experimental data which verifies our proposed methods for using any type of signal transmission from a standalone WiFi device, and demonstrate the capability for human activity sensing.