6 March 2025 in International Journal of Occupational Safety and Ergonomics
This study examines the interplay of weave patterns, picks per inch (PPI) and key performance metrics including heat protective performance (HPP), air permeability, thermal resistance and water vapor transmission rate (WVTR). Three weave structures (twill, sateen and honeycomb) using Nomex-IIIA yarn were tested. Heat flux of 80 ± 2 kW/m2 was applied, combining flame and radiative heat. The honeycomb weave exhibited superior heat protection compared to twill and sateen. HPP increased by approximately 24% with the PPI rising from 40 to 64. Air permeability and thermal conductivity decreased by roughly 50% and 38%, respectively, with increasing PPI. Sateen and twill showed similar trends. WVTR increased with PPI up to 52, then declined. Overall, higher PPI enhanced HPP for all weave structures, with the honeycomb structure showing the best performance. Thermal conductivity and air permeability decreased as PPI increased due to the greater compactness in these three fabrics.
27 September 2025 in AATCC Journal of Research
Low-stress mechanical properties are essential in enhancing comfort, durability, and aesthetic attributes. These properties significantly influence fabrics’ overall performance and tactile comfort in various applications. Meta-aramid yarn was used to develop the fire protective station wear of various weave structures like plain, basket, and ripstop. The linear density of the yarn was 29.5 Tex, and three different PPCs (picks per centimetre) of 15.7, 18.1, and 20.5 were considered for the manufacture of the fabrics. The low-stress mechanical properties such as tensile properties (tensile linearity and tensile energy), shear properties (shear hysteresis (2HG and 2HG5) and shear rigidity), bending properties (bending rigidity, bending hysteresis), and compressional energy were investigated using the Kawabata evaluation system (KES). The effect of weave structures on the low-stress mechanical properties of various fabrics was analysed. The linearity of the tensile load extension curve (LT) and the tensile resilience (RT) increased with the increase in weft density for all the weave structures. It was observed that increasing the PPC from 15.7 to 20.5 improved the linearity of the load-extension curve, with LT values rising from 0.38 to 0.58 for plain weave, and increased tensile energy (WT) from 3.55 to 7.3 g.cm/cm 2 for plain weave and from 3.32 to 6.55 g.cm/cm 2 for basket weave. Surface roughness (SMD) also decreased, with values dropping from 10.39 µm to 8.81 µm for plain weave. A complex relationship between weave structure and PPC needs to be considered when optimizing the design and performance of station wear fabrics.
12 February 2026 in Fire and Materials
23 June 2026 in Progress in Engineering Science