1 January 2014 in AIP Conference Proceedings
This article introduces the methodic for the study of smart surfaces using PIV method. The problem of investigation of super- and ultrahydrophobic- surfaces deals with the quantifying description of the fluid flow behavior in the near-wall region. The objective is to realize comparative study of commercial smart surfaces and their interaction of fluid flow according to the assessment of contact angle. The article interprets the results of measurement of fluid behavior over the whole testing chamber and the synchronized near-wall measurement with optimized dynamic range. The results are shown in the correlation of measured contact angle before and after testing and there are explained changes in the flow behavior.
12 May 2017 in EPJ Web of Conferences
EPJ Web of Conferences, open-access proceedings in physics and astronomy
1 January 2019 in Journal of Applied Mechanics and Technical Physics
The paper deals with the problem of ascertaining the value of air flow velocity necessary to prevent electric current through the motion of ionized air between two asymmetrical electrodes. By means...
4 June 2018 in EPJ Web of Conferences
The article deals with the research of mixing process using visualization techniques and IPI method. Characteristics of the size distribution and the evolution of two liquid-liquid phase's disintegration were studied. A methodology has been proposed for visualization and image analysis of data acquired during the initial phase of the mixing process. IPI method was used for subsequent detailed study of the disintegrated droplets. The article describes advantages of usage of appropriate method, presents the limits of each method, and compares them.
16 April 2012 in EPJ Web of Conferences
23 May 2018 in MATEC Web of Conferences
The mixing of two immiscible phases is a process commonly seen in many branches of industry. Whether it be desirable (e.g. mixing of ingredients in chemical or food industry) or undesirable (e.g. sediments or contaminants in water purification) process, it has to be taken into consideration and a detailed description would be beneficial to any end product. This paper deals with a method for observing the volume ratio of two immiscible phases from the state of total separation, during the mixing process until the state of a homogenous mixture using industrial Electrical Impedance Tomography (EIT) system ITS p2+. The paper also shows a great agreement between the data obtained through measurement using this method and data derived from a theoretical formula. Also using EIT the authors were able to provide additional information describing the mixing process in real time.