22 September 2023 in High Voltage
The lifetime model of turn‐to‐turn insulation in inverter‐fed motors is studied. A lifetime model has been built by considering the effect of inverter‐generated high voltage rise rate (d v /d t up to 20 V/ns). This model is followed by the generalised probabilistic model, in which the lifetime is proportional to the n th power of the voltage rise rate. Moreover, by investigating the effect of voltage rise rate on the partial discharge characteristics, it is found that the effect of voltage rise rate on the charge transport process in a voltage cycle is similar to that of the voltage amplitude. The enhanced partial discharge activity and induced charges are responsible for accelerated ageing and thus determine the final lifetime of turn‐to‐turn insulation. In this case, the generalised probabilistic electric lifetime model is applicable to the voltage rise rate as well as the voltage amplitude.
29 September 2025 in Journal of Applied Polymer Science
26 March 2026 in High Voltage
The safe and stable working of dry‐type valve‐side bushings, important components of converter transformers, is essential. In recent years, poor design has led to several core breakdown, flashover and cracking failures. The bushing cores, composed of crepe paper and aluminium foil, exhibit significant anisotropic physical properties due to its arrangement. However, in previous designs and simulations, the epoxy resin impregnated paper (ERIP) material of the core is often treated as isotropic, and even combined with aluminium foil for the thermal and mechanical calculations. This simplification results in considerable deviations between simulated and actual performance. In this paper, radial and axial ERIP slices are prepared and their electrical, thermal and mechanical anisotropy parameters are measured. A new modelling method of bushing anisotropy is proposed. Based on COMSOL Multiphysics 6.2, the electrical–thermal–mechanical–fluid simulation model of ± 800 kV dry‐type valve‐side bushing is established. The results indicate that the anisotropic model exhibits a 19.1% higher temperature rise, a 15.2% higher maximum radial field strength, and an 85.7% lower damage stress margin than those of the isotropic model. These results show that bushing anisotropy cannot be ignored in modelling and design.
17 August 2026 in Journal of Applied Physics
Under negative DC corona with a silicon needle cathode, the discharge phenomenon differs markedly from that of metal electrodes, producing “streamer-like pulses” that exhibit significant randomness. To elucidate the formation mechanism, a two-dimensional axisymmetric pin–plate discharge model based on plasma chemical reactions was established to systematically investigate the kinetic processes and microscopic mechanisms of the silicon needle corona discharge. Compared with small-amplitude pulses, the formation of streamer-like pulses involves substantially higher electron density, electric field intensity, and ion density. The electron distribution is localized within 0.1 mm in front of the needle tip, with a pronounced electric field depression occurring in the region 0.01 − 0.1 mm from the tip. Ion composition analysis reveals that at the peak of small pulses, the dominant positive ions are O4+ and O2+, and negative ions are primarily O2−, whereas at the peak of streamer-like pulses, N4+ and O2+ become the dominant positive ions. Surface conductivity modulates the discharge mode: low conductivity gives large amplitude disparity, whereas high conductivity yields uniform pulses. Although photoionization is enhanced during streamer-like pulses, collisional ionization remains the main source of electron multiplication. This study reveals the synergistic regulation mechanism of silicon needle surface properties and space charge on discharge modes, providing a theoretical basis for understanding corona discharge behaviors on semiconductor electrodes.