31 December 2018 in Nanotechnology
With a band gap value of 1.7 eV, Al 0.2 Ga 0.8 As is one of the ideal III–V alloys for the development of nanowire-based Tandem Solar Cells on silicon. Nevertheless, growing self-catalysed AlGaAs nanowires on silicon by solid-source molecular beam epitaxy is a very difficult task due to the oxidation of Al adatoms by the SiO 2 layer present on the surface. Here we propose a nanowire structure including a p.i.n radial junction inside an Al 0.2 Ga 0.8 As shell grown on a p-GaAs core. The crystalline structure of such self-catalysed nanowires grown on an epi-ready Si(111) substrate (with a thin native SiO 2 layer) was investigated by transmission electronic microscopy and photoluminescence. I ( V ) measurements performed on single nanowires have shown a diode-like behaviour corresponding to the radial p.i.n junction inside the Al 0.2 Ga 0.8 As shell. Moreover, a current generation under the electron beam was evidenced over the entire radial junction along the nanowires by means of electron beam induced current (EBIC) microscopy. The same structure was reproduced on patterned substrates with a SiO 2 mask, producing an ordered hexagonal array. High and uniform yields from 83% to 87% of vertical nanowires were obtained on 0.9 × 0.9 cm 2 patterned areas. EBIC mapping performed on these nanowires confirmed the good electrical properties of the radial junction within the nanowires.
28 September 2018 in Nanoscale
One obstacle for the development of nanowire (NW) solar cells is the challenge to assess and control their nanoscale electrical properties. In this work a top-cell made of p–n GaAs core/shell NWs grown on a Si(111) substrate by Molecular Beam Epitaxy (MBE) is investigated by high resolution charge collection microscopy. Electron Beam Induced Current (EBIC) analyses of single NWs have validated the formation of a homogeneous radial p–n junction over the entire length of the NWs. The radial geometry leads to an increase of the junction area by 38 times with respect to the NW footprint. The interface between the NWs and the Si(111) substrate does not show any electrical loss, which would have led to a decrease of the EBIC signal. Single NW I–V characteristics present a diodic behavior. A model of the radial junction single NW is proposed and the electrical parameters are estimated by numerical fitting of the I–Vs and of the EBIC map. Solar cells based on NW arrays were fabricated and analyzed by EBIC microscopy, which evidenced the presence of a Schottky barrier at the NW/ITO top contact. Improvement of the top contact quality is achieved by thermal annealing at 400 °C, which strongly reduces the parasitic Schottky barrier.
4 May 2022 in Advanced Materials Interfaces
The hexagonal‐2H crystal phase of Ge has recently emerged as a promising direct bandgap semiconductor in the mid‐infrared range providing new prospects of additional opto‐electronic functionalities of group‐IV semiconductors (Ge and SiGe). The controlled synthesis of such hexagonal‐2H Ge phase is a challenge that can be overcome by using wurtzite GaAs nanowires as a template. However, depending on growth conditions, unusual basal stacking faults (BSFs) of I3‐type are formed in the metastable 2H structure. The growth of such core/shell heterostructures is observed in situ and in real time by means of environmental transmission electron microscopy using chemical vapor deposition. The observations provide the first direct evidence of a step‐flow growth of Ge‐2H epilayers and reveal the growth‐related formation of I3‐BSFs during unstable growth. Their formation conditions are dynamically investigated. Through these in situ observations, a scenario can be proposed for the nucleation of I3‐type BSFs that is likely valid for any metastable hexagonal 2H or wurtzite structures grown on m‐plane substrates. Conditions are identified to avoid their formation for perfect crystalline synthesis of SiGe‐2H.
14 February 2023 in Journal of Applied Physics
We present polarized emission from single hexagonal silicon–germanium (hex-SiGe) nanowires. To understand the nature of the band-to-band emission of hex-SiGe, we have performed photoluminescence spectroscopy to investigate the polarization properties of hex-SiGe core–shell nanowires. We observe a degree of polarization of 0.2 to 0.32 perpendicular to the nanowire c-axis. Finite-difference time-domain simulations were performed to investigate the influence of the dielectric contrast of nanowire structures. We find that the dielectric contrast significantly reduces the observable degree of polarization. Taking into account this reduction, the experimental data are in good agreement with polarized dipole emission perpendicular to the c-axis, as expected for the fundamental band-to-band transition, the lowest energy direct band-to-band transition in the hex-SiGe band structure.
9 September 2024 in Applied Physics Letters
Direct bandgap group IV semiconductors, like strained Ge, GeSn, or hexagonal SiGe, are considered promising for photonic integration on silicon. For group IV semiconductor lasers, it is crucial to understand the carrier cooling efficiency toward the band edges. From a fundamental perspective, a study of carrier cooling within the Γ-valley of direct bandgap group IV semiconductors is particularly interesting since the Fröhlich interaction is expected to be very weak or even absent in these materials due to the nonpolar lattice. Intravalley carrier relaxation within the Γ-valley of a nonpolar semiconductor has not been experimentally accessible before since it has always been overshadowed by intervalley processes between energetically close indirect conduction band minima. Here, we study carrier cooling in direct bandgap hexagonal silicon-germanium (hex-SiGe) nanowires, allowing us to study carrier cooling in an isolated Γ-valley that is sufficiently separated from the indirect minima. We obtain a hot carrier cooling time of 180 ps in the Γ-valley of hex-SiGe. Although the cooling is much slower than in bulk polar group III/V materials due to the absence of Fröhlich interaction, it is comparable to the cooling time in an InGaAs MQW laser structure. We conclude that carrier cooling does not inherently limit hex-SiGe to serve as a laser gain material. This result is an important insight into the field of group IV semiconductor lasers.
20 October 2025 in Applied Physics Letters
We report electrical measurements on hexagonal silicon-germanium (hex-SiGe), a group IV alloy with direct bandgap. Electrical contacts are formed by metal alloying and doping is achieved using ion implantation. The metastable hex-SiGe phase is recovered after implantation by solid phase recrystallization. Independent of the metal used, contacts on n-type samples resulted in Schottky barriers due to Fermi level pinning of hex-SiGe. Overall, this constitutes a first step toward use of hex-SiGe for optoelectronic applications.