28 January 2023 in Acta Materialia
4 February 2023 in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
1 January 2021 in International Journal of Engineering
Dissimilar welded joints of AISI 430 and AISI 316L stainless steel were produced by the GMAW process using two different shielding gas mixtures composed of 97Ar-3N2 and 80Ar-19He-1O2. The microstructure of the heat-affected zone was characterized by optical and scanning electron microscopy, and Vickers microhardness measurements were carried out along the cross-section of the specimens. The dissimilar welded joints were submitted to immersion corrosion test in a 10%v/v hydrochloric acid solution for 24 and 72 hours. Afterward, yields strength, tensile strength, and elongation percentage were measured using tensile tests according to ASTM E8 standard. Non-immersed welded joints were used for comparison purposes. An analysis of variance was developed to evaluate the influence of immersion time and shielding gas mixture on yielding strength and tensile strength. The microstructure characterization showed that the heat-affected zone on AISI 430 side was the widest, and it was observed a significant presence of acicular ferrite, martensite, and coarsened ferritic grains. In contrast, on the heat-affected zone on AISI 316L side was not observed coarsening nor refinement of austenite grains. The AISI 430 heat-affected zone showed the maximum hardness values and higher susceptibility to corrosion damage. Tensile tests results evidenced that immersion corrosion tests did not change significantly ultimate strength in comparison to non-immersed specimens while yielding strength and elongation percentage were drastically decreased due to immersion time. According to the p-value, the immersion time is the most influencing factor on yielding strength and tensile strength of the dissimilar welded joints.
1 January 2021 in SSRN Electronic Journal
Fatigue-induced grain growth has been shown to drive high-cycle fatigue crack initiation in nanocrystalline metals. As a potential strategy to suppress such grain growth, particular solute additions are known to stabilize grain boundaries through both thermodynamic and kinetic mechanisms. In previous work, Au additions in nanocrystalline Pt were confirmed to stabilize grain boundaries against thermally-driven grain boundary migration, however the corresponding effect on fatigue resistance was unknown. The present work compared the high-cycle fatigue performance of stabilized Pt-10at%Au to reference pure Pt with a similar initial grain size, using a combination of ex-situ and in-situ scanning electron microscope fatigue tests. Ex-situ tests revealed that the Pt-10Au exhibits substantial improvement in overall fatigue life over Pt, including a 75% elevation of the fatigue endurance limit. The improvement was attributed to enhanced crack initiation resistance, since the Pt-10Au exhibited diminished resistance to crack propagation compared to Pt. Electron backscatter diffraction, transmission kikuchi diffraction, and transmission electron microscopy showed that the pure Pt exhibited extensive fatigue-induced abnormal grain growth, with the largest grains growing to 10 times the size of the initial grain size, whereas the Pt-10Au exhibited inhibited grain growth, with the largest grains growing by approximately a factor of two. This study provides clear evidence that thermodynamic strategies used to impart thermal stability can also contribute to improved high-cycle fatigue resistance via suppression of grain-growth induced crack initiation.