2 April 2007 in Physical Review B
8 March 1993 in Applied Physics Letters
A boiling water treatment of light emitting porous silicon can give rise to a large blue shift of its photoluminescence spectrum and meanwhile strengthen the skeleton of porous Si by filling up many pores with aqueous oxide. A stable blue-green light emission at the peak wavelength down to 500 nm is achieved. FTIR measurements show that the formation of Si dihydride on the sidewall surfaces of the Si rods is not responsible to the visible luminescence for the very thin Si wires.
12 February 2007 in Applied Physics Letters
A thin buffer layer is indispensable for a high power conversion efficiency in an organic solar cell with fullerene (C60) as the acceptor. In present work, the authors proposed that the role of the buffer layer in an organic solar cell is to prohibit the electron transfer from metal to C60, and thus a desired built-in electric field can promote the free carrier collection. The built-in electric field in different organic solar cells with and without the thin C60 layer was studied by the transient photovoltage technique. The experimental results supported our proposal and indicated that the exciton blocking effect reported in the literature might not be the role of the buffer layer.
24 July 2006 in Applied Physics Letters
The role of hole playing in improving electron injection in the presence of an layer at the organic-cathode interface is discussed. It is deduced that, according to the model of tunneling barrier reduction and the carrier transporting mechanism in organic light-emitting devices, electron injection will be enhanced only if holes are injected and accumulated at the organic-buffer interface. The validity of this analysis is well confirmed by experimental results. The observed abnormal characteristic of operating voltage varying with the layer thickness and the efficiency improvement are also well explained by the model.
17 January 1994 in Applied Physics Letters
By using a cold cathode ion gun to ionize the nitrogen gas, the molecular-beam-epitaxy growth of GaN is carried out. The zinc-blende structure GaN epilayer grown on the GaAs(100) substrate with a narrow x-ray diffraction peak width (FWHM) of 23 min and a low carrier concentration of 1017 cm−3 is achieved. The surface optical phonon energies of cubic and hexagonal GaN are experimentally determined to be 82 and 90 meV, respectively.
24 June 2002 in Applied Physics Letters
We report the photoluminescence (PL) properties measured in situ from vacuum-deposited organic films of tris-(8-hydroxyquinoline) aluminum (Alq) doped with 4-(dicyanomethylene)-2-methyl-6(p-dimethylaminostyryl)-4H-pyran (DCM), where the red emission from the guest molecules is due to Förster energy transfer of excited state energy from host to guest. Both bare DCM-doped Alq (Alq:DCM) and bilayer Alq/Alq:DCM films have been studied, with the thickness of the Alq overlayer continuously varied in the latter case. The PL spectra from the bilayer structure contain no Alq contribution when its thickness is below 2.4 nm. Taking the value as the maximum distance for which the Alq exciton can travel in the film and still transfer its energy to a DCM molecule, the minimum DCM concentration in Alq:DCM necessary to produce red emission only can be estimated at 0.31 wt %. The most efficient red emission appears at the DCM concentration of about 1.7 wt %, at which more than 90% Alq-originated excitons are involved in the Förster energy transfer process. There exists a gradual red shift of the PL spectra with increasing DCM concentration, which can be attributed to the polarization and accompanying aggregation tendency of DCM molecules in Alq during the formation of the doped films.