20 March 2023 in Physics in Medicine & Biology
Objective . Early diagnosis and acute knowledge of cerebral disease require to map the microflows of the whole brain. Recently, ultrasound localization microscopy (ULM) was applied to map and quantify blood microflows in 2D in the brain of adult patients down to the micron scale. Whole brain 3D clinical ULM remains challenging due to the transcranial energy loss which reduces significantly the imaging sensitivity. Approach . Large aperture probes with a large surface can increase both the field of view and sensitivity. However, a large active surface implies thousands of acoustic elements, which limits clinical translation. In a previous simulation study, we developed a new probe concept combining a limited number of elements and a large aperture. It is based on large elements, to increase sensitivity, and a multi-lens diffracting layer to improve the focusing quality. In this study, a 16 elements prototype, driven at 1 MHz frequency, was made and in vitro experiments were performed to validate the imaging capabilities of this new probe concept. Main results . First, pressure fields emitted from a large single transducer element without and with diverging lens were compared. Low directivity was measured for the large element with the diverging lens while maintaining high transmit pressure. The focusing quality of 4 × 3cm matrix arrays of 16 elements without/with lenses were compared. In vitro experiments in a water tank and through a human skull were achieved to localize and track microbubbles in tubes. Significance. ULM was achieved demonstrating the strong potential of multi-lens diffracting layer to enable microcirculation assessment over a large field of view through the bones.
7 April 2022 in Physics in Medicine & Biology
Mapping blood microflows of the whole brain is crucial for early diagnosis of cerebral diseases. Ultrasound localization microscopy (ULM) was recently applied to map and quantify blood microflows in 2D in the brain of adult patients down to the micron scale. Whole brain 3D clinical ULM remains challenging due to the transcranial energy loss which significantly reduces the imaging sensitivity. Large aperture probes with a large surface can increase both resolution and sensitivity. However, a large active surface implies thousands of acoustic elements, with limited clinical translation. In this study, we investigate via simulations a new high-sensitive 3D imaging approach based on large diverging elements, combined with an adapted beamforming with corrected delay laws, to increase sensitivity. First, pressure fields from single elements with different sizes and shapes were simulated. High directivity was measured for curved element while maintaining high transmit pressure. Matrix arrays of 256 elements with a dimension of 10 × 10 cm with small ( λ /2), large (4 λ ), and curved elements (4 λ ) were compared through point spread functions analysis. A large synthetic microvessel phantom filled with 100 microbubbles per frame was imaged using the matrix arrays in a transcranial configuration. 93% of the bubbles were detected with the proposed approach demonstrating that the multi-lens diffracting layer has a strong potential to enable 3D ULM over a large field of view through the bones.
28 October 2025 in Nature Communications
Mapping microcirculation at the whole-organ scale in 3D is crucial for understanding vascular pathologies and improving diagnostics. Although 3D ultrasound localization microscopy (ULM) enables microscopic resolution by localizing intravenously injected microbubbles in small animal models, visualizing entire organs in large animals or humans remains challenging due to limited field of view, low sensitivity, and probe technological complexity. Here, we demonstrate how a multi-lens array method overcomes these limitations. Combined with 3D ULM, it maps and quantifies large vascular volumes (up to 120 × 100 × 82 mm³) at high spatial resolution (125–200 µm) with a volumetric acquisition rate of 312 Hz, using low-cost technology. This approach enables deeper insights into hemodynamics from large vessels to pre-capillary arterioles, by providing vast and rich datasets of whole-organ vascularization. It could also facilitate diagnosis of microcirculation disorders and monitoring of small-vessel disease treatments by addressing key limitations of current imaging modalities.
21 July 2025 in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
Advances in 4-D ultrasound imaging open new perspectives in biomedical research by reducing the long-standing challenge of operator dependency. Extensive research efforts are focused on developing next generation of 2-D transducer arrays for 4-D imaging. Here, we present a compact 2-D array design based on hexagonal-shaped transducer elements. We demonstrate that 2-D hexagonal arrays provide an optimal compact sampling, resulting in lower grating lobe levels and an improved imaging quality compared to conventional square-shaped transducer element arrays. A prototype array made of hexagonal transducer elements is presented, and its characterization is provided, demonstrating its imaging capabilities.
24 September 2025 in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
The introduction of genetically encoded gas vesicles (GVs), protein nanostructures with the ability to scatter sound, has created the possibility for deep tissue cellular imaging. GVs establish a platform for biomolecular engineering and were successfully repurposed into acoustic reporter genes and acoustic biosensors. Alongside molecular engineering developments, a method called cross amplitude modulation (xAM) has emerged as the gold standard for non-destructive ultrasound imaging of GVs thanks to its sensitivity and specificity in living biological tissues. Here, we present latest xAM theory and imaging principles. Specifically, we report 1) analytical expressions for the X-wave beam width and primary-to-secondary lobes distance; 2) experimental observations of nondiffractive xAM beams; 3) a method to modulate the secondary lobe level of xAM beams; 4) a demonstration of the incoherent nature of the xAM image noise that can be leverage to increase sensitivity through frame averaging, 5) a beamforming formalism to enhance xAM contrast-to-noise ratio without reducing framerate. Ultimately, the rise of the field of Biomolecular Ultrasound will rest on the co-development of genetically encoded probes and dedicated imaging methods such as xAM and its 3D extension, nonlinear sound-sheet microscopy.