Francesco Carrara

Francesco Carrara

Auto-generated profile, based on publicly available information

Francesco Carrara

Dipartimento di Ingegneria Elettrica Elettronica e dei Sistemi, Università di Catania, Viale A. Doria 6, 95125 Catania, Italy

Research Focus & Metrics

Academic Career Length

22Years (2005-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 August 2009 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
FCFrancesco Carrara
Francesco Carrara
CPCalogero D. Presti
Calogero D. Presti
FPFausto Pappalardo
Fausto Pappalardo
GPGiuseppe Palmisano
Giuseppe Palmisano
In this paper, the potential of load adaptation for enhanced backoff efficiency in RF power amplifiers (PAs) has been investigated through a 0.13-mum silicon-on-insulator (SOI) CMOS fabrication technology. The RF power performance of the adopted SOI CMOS process has been preliminarily characterized by on-wafer load-pull measurements on a custom unit power transistor. A 2.4-GHz 24-dBm 2-V SOI CMOS PA with fully integrated reconfigurable output matching network has then been designed and experimentally characterized. A significant efficiency improvement of up to 34% has been achieved through load adaptation, peak efficiency being as high as 65%. Linear operation has also been demonstrated under two-tone excitation, as a 16-dBm output power has been attained while complying with a - 40-dBc third-order intermodulation distortion specification.

1 May 2007
Verified
Conference Paper
Closed access
CPCalogero D. Presti
Calogero D. Presti
FCFrancesco Carrara
Francesco Carrara
ASAntonino Scuderi
Antonino Scuderi
GPGiuseppe Palmisano
Giuseppe Palmisano
A novel peak detection technique and its integrated circuit implementation are presented. In high-frequency circuits it is often required to know with precision and linearity the peak value of a voltage waveform, in order to compare it with a reference value and act accordingly. The classic peak detectors underestimate the peak value of sharp-peaked signals, and are affected by non-linearity. These limitations can be traded-off with detection speed. The proposed solution improves both linearity and accuracy without compromising speed. This is accomplished by properly combining the output signals of two fast peak detectors. Results show a 3times improvement in detection accuracy.

1 September 2010 in Solid-State Electronics
Verified
Journal Article
Closed access
FCF. Carrara
F. Carrara
CPC.D. Presti
C.D. Presti
ASA. Scuderi
A. Scuderi
GPGiuseppe Palmisano
Giuseppe Palmisano

27 July 2005
Verified
Conference Paper
Closed access
FCF. Carrara
F. Carrara
GPG. Palmisano
G. Palmisano
In this paper a variable-gain up-conversion mixer based on a novel variable-transconductance input stage is presented. The proposed topology allows dc current reuse and reduces the overall transmitter power consumption in wideband code-division multiple access applications. Temperature compensation and decibel-linear characteristic are achieved by means of a control circuit providing a lower than /spl plusmn/1 dB gain error over a 46-dB dynamic range. A 3-dBm output compression point, 13-dB noise figure, and -45-dB adjacent-channel leakage power ratio are obtained under maximum gain conditions.

27 July 2005
Verified
Conference Paper
Closed access
FCF. Carrara
F. Carrara
Angelo ScuderiAngelo Scuderi
Angelo Scuderi
GBG. Bottiglieri
G. Bottiglieri
GPG. Palmisano
G. Palmisano
A monolithic 1.9-GHz linear power amplifier for wideband code-division multiple access wireless transmitters was integrated using a low-cost pure-silicon bipolar process. At a 3.3-V supply voltage, the circuit exhibits a 31-dBm saturated output power, 57% maximum power-added efficiency, and 29-dBm output 1-dB compression point, while using a low quiescent current of 80 mA. Thanks to a linearizing bias network, the power amplifier is able to comply with the standard -33-dBc adjacent-channel leakage power ratio specification up to a 28.3-dBm output power level. The circuit also features temperature-stable RF gain as well as quiescent current control and shut-down functionalities.