17 December 2015 in IEEE Electron Device Letters
We successfully fabricated gate stacks (ZrO 2 /GeO x /Ge) with a subnanometer equivalent oxide thickness (EOT) and low-leakage current on n-/p-Ge through plasma-enhanced atomic layer deposition (ALD). A 0.78-nmthick GeOx was formed through plasma oxidation (i.e., in situ plasma interfacial passivation, followed by 3.48-nm-thick ZrO 2 growth in the same ALD reactor). A subnanometer EOT of N0.9 nm was achieved with a relatively high dielectric constant (roughly 30) of tetragonal-phase ZrO 2 . The gate leakage was N1 x 10 -4 A/cm2 at VFB - 1 V, and roughly 5 x 10-5 A/cm2 at VFB t 1 V on pand n-type Ge, respectively. Our ZrO 2 stabilized in the tetragonal phase, when the post-deposition annealing temperature, was higher than 500 °C. Therefore, the proposed scheme is simple and effective for use in pursuing an ultralow EOT gate dielectric on Ge.
23 March 2017 in IEEE Transactions on Electron Devices
In this paper, we demonstrated the enhancement of thermal stability of nickel germanide (NiGe) alloy up to 600 °C by using titanium nitride (TiN) metal capping. A high ION/IOFF ratio of 2.9 × 10 5 was achieved by capping TiN metal on Ni for NiGe alloy formation at 600 °C. Detailed analyses were performed for realizing the mechanism for TiN capping on NiGe/Ge, including vertical element diffusion profile observation through depth-profiling X-ray photoelectron spectroscopy(XPS), element diffusion distribution by energy-dispersive X-ray spectroscopy mapping, and direct junction leakage current path detection by conductive atomic force microscopy. The experimental results indicated that TiN capping can reduce the risk of agglomeration and form a graded NiGe/Ge Schottky junction that is beneficial for suppressing the degradation of junction leakage. Subsequently, we compared the electrical performance of TiN/NiGe/n-Ge at various N/Ti ratios of TiNs. Based on the depth-profiling XPS results and electrical performance, TiN with an N/Ti ratio of approximately 1:1 can resist the Ni and Ge diffusion, which facilitates the suppression of the agglomeration process. However, the TiN capping layers with an N/Ti ratio of less than approximately 1:1 (Ti-rich) were not favorable for resisting Ni and Ge diffusion.
19 January 2018 in ECS Journal of Solid State Science and Technology
In this study, we employed the electrical and material properties of various interfacial layers (ILs) such as GeO and YGeO on a Ge substrate. First, capacitors using various ILs with HfO2-based gate stacks were developed. The capacitor using YGeO IL exhibited a low interface state density (Dit) of 2.5 × 1011 eV−1cm−2 and an equivalent oxide thickness of 1.8 nm. Next, a reliability test for constant voltage stress was conducted for further studying the YGeO ILs. The capacitors with YGeO ILs presented higher immunity for Dit degradation. Further, to understand the material properties of various ILs, a simple experiment on capping a Si chip on GeO or YGeO/Ge samples through high-temperature annealing was conducted. We observed that Ge and GeO vapors can be absorbed by Si and detected through X-ray photoelectron spectroscopy (XPS). XPS spectra of Si chips capped on GeO IL presented obvious features of Ge and GeO through annealing at 500°C; however, the XPS spectra of Si chips capped on YGeO IL presented no features, indicating that YGeO ILs had higher thermal stability than GeO ILs. To further analyze the HfO2-based gate stacks with various ILs, Ge diffusion into a high-κ HfO2 layer was investigated through angle-resolved XPS. We observed that YGeO ILs with HfO2-based gate stacks can reduce Ge diffusion into a HfO2 layer.
24 September 2018 in IEEE Electron Device Letters
This letter represents the first direct experimental demonstrations and mechanism proposal regarding abnormal palladium diffusion into germanium (Ge). Our experiments indicated that excess Ge atoms among palladium germanide alloy formation indirectly induce the abnormal out-diffusion of mass palladium atoms into Ge. Consequently, palladium germanide alloy on both n-type and p-type Ge form ohmic-like Schottky junctions. To identify this phenomenon, first-principle calculations and technology computer-aided design simulation were used to evaluate the electrical influence of palladium atoms in Ge. We discovered that the activated palladium atoms in Ge induce large midgap bulk-trap states, which contribute to a severe increment of trap-assisted tunneling current at the palladium germanide/Ge junction.