We report systematic analysis and comparison of ps-laser microwelding of industry relevant Al6082 parts to and BK7. Parameter mapping of pulse energy and focal depth on the weld strength is presented. The welding process was found to be strongly dependent on the focal plane but has a large tolerance to variation in pulse energy. Accelerated lifetime tests by thermal cycling from to are presented. Welds in Al6082-BK7 parts survive over the full temperature range where the ratio of thermal expansion coefficients is 3.4:1. Welds in parts (ratio 47.1:1) survive only a limited temperature range.
A single-frequency single-pass amplifier based on Ho:YLF and Ho:LuLF in a scalable slab architecture delivering up to 210 mJ at 2064 nm is demonstrated. The amplifier was end-pumped by a 1890 nm Tm:YLF slab laser and was seeded with a 69 mJ single-frequency Ho:YLF ring laser operating at 50 Hz.
We report on a double-pass Ho:YLF slab amplifier which delivered 350 ns long single-frequency pulses of up to 330 mJ at 2064 nm, with a maximum of 1.5 at 50 Hz. It was end pumped with a diode-pumped Tm:YLF slab laser and seeded with up to 50 mJ of single-frequency pulses.
An end-pumped Nd:YLF laser was demonstrated, which delivered 60.3 W continuous-wave and more than 52 W Q-switched average power for all repetition rates from 5 to 30 kHz. To achieve this, an analytical solution to estimate and optimize the unsaturated gain in an end-pumped laser gain medium was derived. The approach presented here should open up the route for scaling end-pumped lasers to even higher power and energy levels.
A 1314 nm Nd:YLF laser was designed and operated both CW and passively -switched. Maximum CW output of 10.4 W resulted from 45.2 W of incident pump power. Passive -switching was obtained by inserting a V:YAG saturable absorber in the cavity. The oscillator delivered a maximum of 825 μJ energy per pulse, with a pulse duration of 135 ns at a pulse repetition frequency of 6.3 kHz, effectively delivering 5.2 W of average power.