27 September 2021 in IEEE Sensors Journal
The underwater glider (UG) is a new type of long-endurance marine vehicle that is currently widely used in marine environment surveillance. However, the limited capability of underwater communication and the uncertainty of the marine environment leads to a large deviation between the dead-reckoned trajectory and the real trajectory of UG. Therefore, a localization and navigation method based on ocean current data is proposed in this study. Firstly, the working principle and configuration of UG are illustrated, and the dynamic model is also analyzed. Then, the depth-averaged current is derived with motion parameters of UG, and the ocean current data from the Hybrid Coordinate Ocean Model is also introduced and processed. Meanwhile, to make an accurate localization, the DAC is stratified according to the layer weight extracted from the processed ocean current model to obtain layered DAC (LDAC). Subsequently, because the sample intervals of sensors are asynchronous with LDAC, a new matching algorithm based on sample time difference is presented to match the information of sensors and LDAC. Furthermore, the matched data is applied to localization for accurate dead reckoning. Finally, based on the data collected from two experiments, the LDAC-aided localization method proposed in this paper is compared with other benchmark positioning methods, including dynamic model-aided localization, sea current-aided localization, and acoustic beacon-aided localization methods. The results indicate that the proposed new method achieves better localization performance than other benchmark methods. In addition, the proposed method could be applied to other autonomous vehicles with communication constraints.
23 October 2023 in IEEE Journal of Oceanic Engineering
It is difficult for traditional underwater gliders (UGs) equipped with rigid hulls to compensate for the buoyancy loss caused by seawater density variation and reduce the vibration noise. Inspired by the streamlined shape and soft body of seals, this article develops a bionic UG with appropriate buoyancy compensation and vibration and noise reduction. The seal-inspired underwater glider (SIUG) contains a rigid-flexible composite hull, with the outer flexible silicone rubber shell completely covering the inner rigid hull. A vibration experiment is performed, and the results verify that the proposed hull can obviously suppress the propagation of vibration noise, especially the high-frequency ones. Further, the dynamic models of the SIUG and the traditional rigid UG are established, respectively, to compare their dynamic behaviors. The dynamic simulation results show that the net buoyancy of the SIUG remains almost unchanged in deep water, with obviously smaller fluctuations of pitch angle and velocity. A sea trial in the South China Sea also proves that the SIUG has a good capability of buoyancy compensation in maintaining its net buoyancy. Overall, the SIUG provides a two-in-one solution of buoyancy compensation as well as vibration and noise reduction.
8 September 2016 in Journal of Vibration and Acoustics
Free-falling microstructure profiler (FFMP) is the most effective platform for measuring ocean microstructure turbulence. Vibration is the key factor of influencing the accuracy of the measurement of the shear sensor mounted on the leading end of the FFMP. In the present work, vibration behavior of an FFMP called FFMP1000 was studied through fluid–structure interaction (FSI) simulations and field trials. Vibration characteristics and mechanism of the FFMP1000 were also discussed. Results showed that motion of the FFMP was like a compound pendulum oscillation, and was caused by vortex shedding at the trailing end of the FFMP. Empirical formulas used to predict the oscillation of the FFMP were deduced based on the characteristics of motion behavior and confirmed through sea trials. The present achievement provides scientific guidance for designing optimal hydrodynamic hull shape of the FFMP. It is also useful to estimate the low end detection limit of the FFMP and to modify the turbulence kinetic energy dissipation rate during ocean observations.
6 November 2026 in Ships and Offshore Structures
1. Marine environmental observation requires sustained acquisition of high-resolution in situ data over large spatial and temporal scales under dynamically complex ocean conditions. These requireme...