Aryl‐ether‐free anion‐exchange ionomers (AEIs) and membranes (AEMs) have become an important benchmark to address the insufficient durability and power‐density issues associated with AEM fuel cells (AEMFCs). Here, we present aliphatic chain‐containing poly(diphenyl‐terphenyl piperidinium) (PDTP) copolymers to reduce the phenyl content and adsorption of AEIs and to increase the mechanical properties of AEMs. Specifically, PDTP AEMs possess excellent mechanical properties (storage modulus>1800 MPa, tensile strength>70 MPa), H2fuel‐barrier properties (7.6 A cm−2current density) and 1.38 W cm−2at 80 °C in H2/O2and H2/air, respectively, along with a specific power (PPD/catalyst loading) over 8 W mg−1, which is the highest record for Pt‐based AEMFCs so far.
Aryl‐ether‐free anion‐exchange ionomers (AEIs) and membranes (AEMs) have become an important benchmark to address the insufficient durability and power‐density issues associated with AEM fuel cells (AEMFCs). Here, we present aliphatic chain‐containing poly(diphenyl‐terphenyl piperidinium) (PDTP) copolymers to reduce the phenyl content and adsorption of AEIs and to increase the mechanical properties of AEMs. Specifically, PDTP AEMs possess excellent mechanical properties (storage modulus>1800 MPa, tensile strength>70 MPa), H2fuel‐barrier properties (7.6 A cm−2current density) and 1.38 W cm−2at 80 °C in H2/O2and H2/air, respectively, along with a specific power (PPD/catalyst loading) over 8 W mg−1, which is the highest record for Pt‐based AEMFCs so far.
We report a hybrid technique for extraction of structure- and gate-bias-dependent parasitic source/drain (S/D) resistances (RS and RD) in amorphous indium-gallium-zinc oxide (a-IGZO) thin-film transistors (TFTs). In the proposed technique, C- V and I -V measurements are combined for modeling and extraction. As structural dependence, the active-layer thickness TIGZO , the gate length L, and the overlap length Lov between the S/D and the gate are considered in the equivalent circuit for parasitic resistances. We also separated the horizontal component RH considering the transfer resistance RLT depending on the transfer length LT and the channel resistance RCH, as well as the vertical components in the S/D RVS and RVD. We confirmed the proposed technique through a separate extraction of VGS -independent contact resistances (RCS, RCD) from the channel length- and VGS-dependent RLT and RCH.
1 March 2021 in Angewandte Chemie International Edition
Poly(alkyl‐terphenyl piperidinium) ionomers and membranes were used for H2–O2 anion exchange membrane fuel cells, and achieved a high power density of 2.58 W cm−2, which is a new record for polyaromatic‐based fuel cells. Details of the study are described by Young Moo Lee and co‐workers in their Research Article on page 7710.