23 November 2022 in Materials & Design
3 October 2023 in Journal of Vacuum Science & Technology B
Titanium and titanium alloys are the most commonly used implant materials, but they are biologically inert. These materials lack rapid osseointegration and resistance to bacterial infections, problems that remain unsolved. The preparation of titanium dioxide coatings by microarc oxidation improves both the biocompatibility of titanium-based materials and their resistance to corrosion during long-term presence in the body. This paper discusses and summarizes the mechanisms of microarc oxidation and some classical models that need to be developed to provide a better understanding and guidance for future research. Subsequently, the effects of electrolyte type, additives, and surface modification of the microarc oxidized coating on the coating morphology were analyzed in detail. In addition, biological applications of microarc oxidation coatings are analyzed, including antimicrobial properties, osseointegration, hydrophilicity, corrosion resistance, and wear resistance.
1 January 2022 in SSRN Electronic Journal
It is still challenge to fabricate copper alloys due to excellent thermal properties and high reflective to laser beams during Laser powder bed fusion (LPBF) process. As such, the short-wavelength green laser beam has been employed in present work to fabricate copper-chromium-zirconium (CuCrZr) alloys in present work. To enhance performance, post-heat-treatment was employed on the alloys. The mechanical properties in present work are superior to most of LPBF-built CuCrZr alloys using conventional infrared laser. So far, most of studies about additive manufactured (AM-ed) CuCrZr alloys only focus properties of alloys perpendicular to build directions. Hence, the mechanical behaviors (tensile properties and Vick Hardness tests) and physical properties (electrical and thermal conductivities) of LPBF-built alloys along different build orientations were investigated. In order to reveal the microstructures of the alloys, the characterizations of scanning electron microscope (SEM), transmission electron microscope (TEM) and electron backscatter diffraction (EBSD) were performed, including texture, misorientation angle, Schmid factor. The slender columnar grains were observed. Nevertheless, heat-treated samples along transverse directions own better mechanical properties (yield strength (YS): 505 MPa, ultimate tensile strength(UTS): 585 MPa, Elongation (EL): 14.4%) and better thermal properties (307 W/mK). While the heat-treated samples along build directions own lower strength (YS: 472 MPa, UTS: 495 MPa) with better ductility (EL: 17.8%) and poor thermal conductivity (255 W/mK). The mechanical and thermal anisotropy attributes the stronger {110} grain orientation and lower fraction of LAGBs along build directions due to the columnar structure with fine equiaxed grains.
1 January 2022 in SSRN Electronic Journal
Copper-Chromium-Zirconium (CuCrZr) can be tailed by additive manufacturing, especially selective laser melting. The present works aim for SLM process and post heat treatments of CuCrZr alloy, especially a direct ageing hardening. By direct ageing treatment at 500 °C for an hour, excellent mechanism properties (ultimate tensile strength = 585 MPa, YS = 500 MPa, total failure elongation = 14.4%, Vick hardness = 161 HV) were achieved while keeping a good conductivity (64% IACS). The main contribution for the increment of YS is attributed to (I) the nano-scaled Cr precipitated homogenously in the copper matrix during directly ageing treatment and (II) remaining high dislocation density near the dislocation cells.