Understanding the rheological properties of the upper mantle is essential to develop a consistent model of mantle dynamics and plate tectonics. However, the spatial distribution and temporal evolution of these properties remain unclear. Here, we infer the rheological properties of the asthenosphere across multiple great megathrust earthquakes between 2004 and 2014 along the Sumatran subduction zone, taking advantage of decade-long continuous GPS and tide-gauge measurements. We observe transient mantle wedge flow following these earthquakes, and infer the temporal evolution of the effective viscosity. We show that the evolution of stress and strain rate following these earthquakes is better matched by a bi-viscous than by a power-law rheology model, and we estimate laterally heterogeneous transient and background viscosities on the order of ~1017 and ~1019 Pa s, respectively. Our results constitute a preliminary rheological model to explain stress evolution within earthquake cycles and the development of seismic hazard in the region.
Deformation associated with plate convergence at subduction zones is accommodated by a complex system involving fault slip and viscoelastic flow. These processes have proven difficult to disentangle. The 2010 Mw 8.8 Maule earthquake occurred close to the Chilean coast within a dense network of continuously recording Global Positioning System stations, which provide a comprehensive history of surface strain. We use these data to assemble a detailed picture of a structurally controlled megathrust fault frictional patchwork and the three-dimensional rheological and time-dependent viscosity structure of the lower crust and upper mantle, all of which control the relative importance of afterslip and viscoelastic relaxation during postseismic deformation. These results enhance our understanding of subduction dynamics including the interplay of localized and distributed deformation during the subduction zone earthquake cycle.
31 July 2019 in Natural Hazards and Earth System Sciences
Seismogenic tsunami hazard assessments are highly dependent on the reliability of earthquake source models. Here in a study of the Manila subduction zone (MSZ) system, we combine the geological characteristics of the subducting plate, geometry, and coupling state of the subduction interface to propose a series of fault rupture scenarios. We divide the subduction zone into three rupture segments: 14–16, 16–19, and 19–21.7∘ N inferred from geological structures associated with the down-going Sunda plate. Each of these segments is capable of generating earthquakes of a magnitude between Mw=8.5+ and Mw=9+, assuming a 1000-year seismic return period as suggested by previous studies. The most poorly constrained segment of the MSZ lies between 19 and 21.7∘ N, and here we use both local geological structures and characteristics of other subduction zone earthquakes around the world, to investigate the potential rupture characteristics of this segment. We consider multiple rupture modes for tsunamigenic earthquake and megathrust-splay fault earthquakes. These rupture models facilitate an improved understanding of the potential tsunami hazard in the South China Sea (SCS). Hydrodynamic simulations demonstrate that coastlines surrounding the SCS could be devastated by tsunami waves up to 10 m if large megathrust earthquakes occur in these segments. The regions most prone to these hazards include west Luzon of Philippines, southern Taiwan, southeastern China, central Vietnam, and Palawan Island.
21 December 2016 in Journal of Geophysical Research: Solid Earth
We reveal transient surface deformation following the 2017 Mw7.3 Sarpol Zahab (Iran) earthquake using Interferometric Synthetic Aperture Radar (InSAR) measurements. Based on the coseismic interferograms derived from the Advanced Land Observing Satellite‐2 (ALOS‐2) data, the preferred slip model of the earthquake has a centroid depth of 14.5 ± 4 km and suggests that a basement fault is most likely responsible for the 2017 earthquake in the northwest Zagros fold‐thrust belt zone. Two slip asperities with a maximum slip of 6 m separated by 16 km are observed in the best fitting slip model. The accumulated afterslip in the first month after the mainshock determined from the Sentinel‐1 postseismic interferograms reveals a slip distribution that lies immediately updip of the coseismic slip, implying that frictional properties of the fault vary along the rupture patch. The Bamo Mount in the earthquake area was uplifted by approximately 1 m during the earthquake. We suggest that local topographic growth from both seismic and aseismic faulting behaviors is common within the Zagros fold‐thrust belt zone based on our findings regarding the 2017 earthquake and other significant events in the region.