Giuseppe Scionti

Giuseppe Scionti

Auto-generated profile, based on publicly available information

Giuseppe Scionti

Department of Histology (Tissue Engineering Group), Faculty of Medicine, University of Granada, Granada, Spain

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 August 2013 in Journal of Biomedical Materials Research Part A
Verified
Journal Article
Open access
PDF file
GSGiuseppe Scionti
Giuseppe Scionti
MMMoral Muñoz
Moral Muñoz
MTManuel Toledano-Osorio
Manuel Toledano-Osorio
Raquel OsorioRaquel Osorio
Raquel Osorio
JDJ. D. G. Durán
J. D. G. Durán
Modesto Torcuato Lopez-LopezModesto Torcuato Lopez-Lopez
Modesto Torcuato Lopez-Lopez
The effect of hydration on the biomechanical properties of fibrin and fibrin‐agarose (FA) tissue‐like hydrogels is reported. Native hydrogels with approximately 99.5% of water content and hydrogels with water content reduced until 90% and 80% by means of plastic compression (nanostructuration) were generated. The biomechanical properties of the hydrogels were investigated by tensile, compressive, and shear tests. Experimental results indicate that nanostructuration enhances the biomechanical properties of the hydrogels. This improvement is due to the partial draining of the water that fills the porous network of fibers that the plastic compression generates, which produces a denser material, as confirmed by scanning electron microscopy. Results also indicate that the characteristic compressive and shear parameters increase with agarose concentration, very likely due to the high water holding capacity of agarose, which reduces the compressibility and gives consistency to the hydrogels. However, results of tensile tests indicate a weakening of the hydrogels as agarose concentration increases, which evidences the anisotropic nature of these biomaterials. Interestingly, we found that by adjusting the water and agarose contents it is possible to tune the biomechanical properties of FA hydrogels for a broad range, within which the properties of many native tissues fall. © 2013 Wiley Periodicals, Inc. J Biomed Mater Res Part A: 102A: 2573–2582, 2014.

24 July 2015 in PLOS ONE
Verified
Journal Article
Open access
PDF file
Modesto Torcuato Lopez-LopezModesto Torcuato Lopez-Lopez
Modesto Torcuato Lopez-Lopez
GSGiuseppe Scionti
Giuseppe Scionti
AOAna C. Oliveira
Ana C. Oliveira
JDJuan D. G. Duran
Juan D. G. Duran
ACAntonio Campos
Antonio Campos
IRIsmael A. Rodriguez
Ismael A. Rodriguez
We report the preparation of novel magnetic field-responsive tissue substitutes based on biocompatible multi-domain magnetic particles dispersed in a fibrin–agarose biopolymer scaffold. We characterized our biomaterials with several experimental techniques. First we analyzed their microstructure and found that it was strongly affected by the presence of magnetic particles, especially when a magnetic field was applied at the start of polymer gelation. In these samples we observed parallel stripes consisting of closely packed fibers, separated by more isotropic net-like spaces. We then studied the viability of oral mucosa fibroblasts in the magnetic scaffolds and found no significant differences compared to positive control samples. Finally, we analyzed the magnetic and mechanical properties of the tissue substitutes. Differences in microstructural patterns of the tissue substitutes correlated with their macroscopic mechanical properties. We also found that the mechanical properties of our magnetic tissue substitutes could be reversibly tuned by noncontact magnetic forces. This unique advantage with respect to other biomaterials could be used to match the mechanical properties of the tissue substitutes to those of potential target tissues in tissue engineering applications.

1 February 2014 in Cytotherapy
Verified
Journal Article
Open access
MMMiguel Ángel Martin-Piedra
Miguel Ángel Martin-Piedra
IGIngrid Garzon
Ingrid Garzon
AOAna Celeste Oliveira
Ana Celeste Oliveira
CACamilo Andres Alfonso-Rodriguez
Camilo Andres Alfonso-Rodriguez
Víctor CarrielVíctor Carriel
Víctor Carriel
MAMiguel Alaminos
Miguel Alaminos
Evaluation of cell viability is one of the most important steps of the quality control process for therapeutic use of cells. The aim of this study was to evaluate the long-term cell viability profile of human dental pulp stem cell (hDPSC) subcultures (beyond 10 passages) to determine which of these passages are suitable for clinical use and to identify the cell death processes that may occur in the last passages. Four different cell viability assays were combined to determine the average cell viability levels at each cell passage: trypan blue exclusion test, water-soluble tetrazolium 1 (WST-1), LIVE/DEAD Viability/Cytotoxicity Kit and electron probe x-ray microanalysis (EPXMA). Apoptosis was assessed by terminal deoxynucleotidyl transferase dUTP nick end labeling (TUNEL) assay and caspase 4 and BCL7C Western blotting, and cell proliferation was analyzed by WST-1 and proliferating cell nuclear antigen protein detection. hDPSCs showed high average cell viability levels from passages 11-14, with adequate cytoplasmic and mitochondrial functionality at these subcultures. A non-significant trend to decreased cell proliferation was found from passages 16-20. EPXMA and TUNEL analyses suggested that a pre-apoptotic process could be activated from passages 15-20 (P < 0.001), with a correlation with caspase 4 and BCL7C expression. hDPSCs corresponding to passages 11-14 show adequate cell function, proliferation and viability. These cells could be considered as potentially useful for clinical applications.

14 July 2015 in Journal of Tissue Engineering and Regenerative Medicine
Verified
Journal Article
Open access
PDF file
Víctor CarrielVíctor Carriel
Víctor Carriel
GSGiuseppe Scionti
Giuseppe Scionti
FCFernando Campos
Fernando Campos
OROlga Roda
Olga Roda
Begoña CastroBegoña Castro
Begoña Castro
MAMiguel Alaminos
Miguel Alaminos
Neural tissue engineering is focused on the design of novel biocompatible substitutes to repair peripheral nerve injuries. In this paper we describe a nanostructured fibrin–agarose bioartificial nerve substitute (NFABNS), based on nanostructured fibrin–agarose hydrogels (FAHs) with human adipose-derived mesenchymal stem cells (HADMSCs). These NFABNSs were mechanically characterized and HADMSCs behaviour was evaluated using histological and ultrastructural techniques. Mechanical characterization showed that the NFABNSs were resistant, flexible and elastic, with a high deformation capability. Histological analyses carried out in vitro during 16 days revealed that the number of HADMSCs decreased over time, with a significant increase after 16 days. HADMSCs formed cell clusters and degraded the surrounding scaffold during this time; additionally, HADMSCs showed active cell proliferation and cytoskeletal remodelling, with a progressive synthesis of extracellular matrix molecules. Finally, this study demonstrated that it is possible to generate biologically active and mechanically stable tissue-like substitutes with specific dimensions, based on the use of HADMSCs, FAHs and a nanostructure technique. However, in vivo analyses are needed to demonstrate their potential usefulness in peripheral nerve repair. Copyright © 2015 John Wiley & Sons, Ltd.

7 November 2014 in PLOS ONE
Verified
Journal Article
Open access
PDF file
CACamilo-Andrés Alfonso-Rodríguez
Camilo-Andrés Alfonso-Rodríguez
IGIngrid Garzón
Ingrid Garzón
JGJuan Garrido-Gómez
Juan Garrido-Gómez
AOAna-Celeste-Ximenes Oliveira
Ana-Celeste-Ximenes Oliveira
MMMiguel Ángel Martin-Piedra
Miguel Ángel Martin-Piedra
MAMiguel Alaminos
Miguel Alaminos
Dupuytren's disease is a fibro-proliferative disease characterized by a disorder of the extracellular matrix (ECM) and high myofibroblast proliferation. However, studies failed to determine if the whole palm fascia is affected by the disease. The objective of this study was to analyze several components of the extracellular matrix of three types of tissues—Dupuytren's diseased contracture cords (DDC), palmar fascia clinically unaffected by Dupuytren's disease contracture (NPF), and normal forehand fascia (NFF). Histological analysis, quantification of cells recultured from each type of tissue, mRNA microarrays and immunohistochemistry for smooth muscle actin (SMA), fibrillar ECM components and non-fibrillar ECM components were carried out. The results showed that DDC samples had abundant fibrosis with reticular fibers and few elastic fibers, high cell proliferation and myofibroblasts, laminin and glycoproteins, whereas NFF did not show any of these findings. Interestingly, NPF tissues had more cells showing myofibroblasts differentiation and more collagen and reticular fibers, laminin and glycoproteins than NFF, although at lower level than DDC, with similar elastic fibers than DDC. Immunohistochemical expression of decorin was high in DDC, whereas versican was highly expressed NFF, with no differences for aggrecan. Cluster analysis revealed that the global expression profile of NPF was very similar to DDC, and reculturing methods showed that cells corresponding to DDC tissues proliferated more actively than NPF, and NPF more actively than NFF. All these results suggest that NPF tissues may be affected, and that a modification of the therapeutic approach used for the treatment of Dupuytren's disease should be considered.

27 August 2020 in Metals
Verified
Journal Article
Open access
PDF file
EVElia Vidal
Elia Vidal
DTDiego Torres
Diego Torres
JGJordi Guillem-Marti
Jordi Guillem-Marti
GSGiuseppe Scionti
Giuseppe Scionti
Jose Maria ManeroJose Maria Manero
Jose Maria Manero
ERElisa Rupérez
Elisa Rupérez
Titanium (Ti) and Ti alloys have been used for decades for bone prostheses due to its mechanical reliability and good biocompatibility. However, the high stiffness of Ti implants and the lack of bioactivity are pending issues that should be improved to minimize implant failure. The stress shielding effect, a result of the stiffness mismatch between titanium and bone, can be reduced by introducing a tailored structural porosity in the implant. In this work, porous titanium structures were produced by direct ink writing (DIW), using a new Ti ink formulation containing a thermosensitive hydrogel. A thermal treatment was optimized to ensure the complete elimination of the binder before the sintering process, in order to avoid contamination of the titanium structures. The samples were sintered in argon atmosphere at 1200 °C, 1300 °C or 1400 °C, resulting in total porosities ranging between 72.3% and 77.7%. A correlation was found between the total porosity and the elastic modulus of the scaffolds. The stiffness and yield strength were similar to those of cancellous bone. The functionalization of the scaffold surface with a cell adhesion fibronectin recombinant fragment resulted in enhanced adhesion and spreading of osteoblastic-like cells, together with increased alkaline phosphatase expression and mineralization.