Three patch antennas suitable for integration and operation in a compact 24 GHz wireless sensor node with radar and communication functions are designed, characterized, and compared. The antennas are manufactured on a low loss glass wafer using thin film (BCB/Cu) wafer level processing (WLP) technologies. This process is well suited for 3D stacking. The antennas are fed through a microstrip line underneath a ground plane coupling into the patch resonator through a slot aperture. Linear polarization (LP), dual mode (DM) operation, and circular polarization (CP) are achieved through the layout of the slot aperture and rectangular patch dimensions. Antenna gain values of ∼5.5 dBi are obtained in addition to the 10 dB impedance bandwidths of 900 MHz and 1.3 GHz as well as 500 MHz CP bandwidth with a 3 dB axial ratio for the LP, DM, and CP patch antennas, respectively.
7 July 2016 in IEEE Transactions on Microwave Theory and Techniques
Due to manufacturing requirements, surface finishes have become a necessity in printed circuit board design. These finishes have significant effects on the RF performance of the transmission lines. In this paper, a filament modeling approach is used to model skin, proximity, and surface roughness effects in transmission lines with surface finishes up to 70 GHz. The approach shows a high accuracy compared with measurements. The model also gives an insight into how the current distributes itself by showing the frequency dependent proportion of the current that flows in each surface finish layer. In the case of NiP-Au or Ni-Au surface finishes, current migrates increasingly into gold at high frequencies and reaches a maximum in the Ni or NiP at around 3.5 GHz, and then declines. The distribution of the current in different materials can also be explained as the decay of an electromagnetic wave at the surface of the conductor. This approach shows that the evanescent wave in the cross section of the conductor can be analyzed as analog to a transmission- reflection problem, what we will call the surface finish effect. This effect brings into question the accuracy of the traditional skin-depth value, δ, and the models that depend on it, such as most surface roughness correction factors, for structures where different metals are layered in thicknesses that are not much larger than δ.
22 June 2018 in IEEE Transactions on Components, Packaging and Manufacturing Technology
High-gain steerable antenna arrays in the K-, Ka-, and V-frequency bands have the potential to facilitate high-bandwidth satellite communication for a variety of applications. Copper-core printed circuit boards (PCBs) can offer a cost-effective integration platform for such systems by simultaneously addressing both the high frequency and thermal challenges. Integrating GaAs dies into test vehicles has shown that copper-core PCBs can be automatically assembled and provide high-frequency systems that show adequate reliability during thermal cycling. A single 60-GHz transmitter front end, designed to drive a single element of a phased array, with a 2-GHz bandwidth signal, composed of four GaAs dies, including a phase shifter, integrated onto a copper-core PCB produces an output power of -4 dBm and maintains an on-chip temperature under 51 °C.
Through Silicon Vias (TSVs) are expected to play an increasingly important role in next-generation microelectronics packaging. Even when the challenge of attenuation is overcome, crosstalk remains a major concern in TSV design. In this paper, it is shown that, at frequencies above 20 GHz, near-end crosstalk can easily exceed -20 dB. Traditional analytical models for crosstalk are compared to full-wave simulations to determine their limitations and a lumped element equivalent circuit model is presented. An examination of the impact of TSV dimensions is presented. Then, three TSV structures are compared and the impact of their dimensions on crosstalk is investigated.
The microprocessor chip for the IBM zEnterprise 196 (z196) system is a high frequency, high-performance design that adds support for out-of-order instruction execution and increases operating frequency by almost 20% compared to the previous 65nm design, while still fitting within the same power envelope. Despite the many difficult engineering hurdles to be overcome, the design team was able to achieve a product frequency of 5.2GHz, providing a significant per formance boost for the new system.