1 February 2009 in Journal of Consumer Protection and Food Safety
3 April 2018 in Soldering & Surface Mount Technology
Purpose: Cu/Cu diffusion bonding is characterised by high electrical and thermal conductivity, as well as the mechanical strength of the interconnects. But despite a number of advantages, Cu oxidises readily upon exposure to air. To break through the adsorbed oxide-layer high temperature and pressure, long bonding time and inert gas atmosphere are required during the bonding process. This paper aims to present the implementation of an organic self-assembled monolayer (SAM) as a temporary protective coating that inhibits Cu oxidation. Design/methodology/approach: Information concerning elemental composition of the Cu surface has been yielded by X-ray photoelectron spectroscopy (XPS) and Fourier-transform infrared (FTIR) spectroscopy. Two types of substrates (electroplated and sputtered Cu) are prepared for thermocompression bonding in two different ways. In the first case, Cu is cleaned with dilute sulphuric acid to remove native copper oxide. In the second case, passivation with SAM followed the cleaning step with dilute sulphuric acid. Shear strength, fracture surface, microstructure of the received Cu/Cu interconnects are investigated after the bonding procedure. Findings: The XPS method revealed that SAM can retard Cu from oxidation on air for at least 12 h. SAM passivation on the substrates with sputtered Cu appears to have better quality than on the electroplated ones. This derives from the results of the shear strength tests and scanning electron microscopy (SEM) imaging of Cu/Cu interconnects cross sections. SAM passivation improved the bonding quality of the interconnects with sputtered Cu in comparison to the cleaned samples without passivation. Originality/value: The Cu/Cu bonding procedure was optimised by a novel preparation method using SAMs which enables storage and bonding of Si-dies with Cu microbumps at air conditions while remaining a good-quality interconnect. The passivation revealed to be advantageous for the smooth surfaces. SEM and shear strength tests showed improved bonding quality for the passivated bottom dies with sputtered Cu in comparison to the samples without SAM.
7 February 2010 in International Journal of Microwave Science and Technology
Three patch antennas suitable for integration and operation in a compact 24 GHz wireless sensor node with radar and communication functions are designed, characterized, and compared. The antennas are manufactured on a low loss glass wafer using thin film (BCB/Cu) wafer level processing (WLP) technologies. This process is well suited for 3D stacking. The antennas are fed through a microstrip line underneath a ground plane coupling into the patch resonator through a slot aperture. Linear polarization (LP), dual mode (DM) operation, and circular polarization (CP) are achieved through the layout of the slot aperture and rectangular patch dimensions. Antenna gain values of ∼5.5 dBi are obtained in addition to the 10 dB impedance bandwidths of 900 MHz and 1.3 GHz as well as 500 MHz CP bandwidth with a 3 dB axial ratio for the LP, DM, and CP patch antennas, respectively.