11 August 2020 in IEEE Transactions on Geoscience and Remote Sensing
An algorithm for detecting coherence in Cyclone Global Navigation Satellite System (CYGNSS) mission delay-Doppler maps (DDMs) is presented. Because CYGNSS DDMs report only the observed power without phase information, the algorithm uses estimates of power ``spread'' within the DDM to flag coherency. Since the estimate used is a ratio of the powers in differing portions of the DDM, it is less sensitive to absolute power calibration and to the GPS C/A code type observed, and is applied to CYGNSS Level-1 uncalibrated DDMs. The basic detector formulation is described along with modifications to improve performance in lower signal-to-noise ratio (SNR) situations. The required detection thresholds are determined using matchups with CYGNSS ``Raw I/F'' mode measurements for which the DDM phase can be computed and used to identify coherence more precisely. Application of the final detector over a large CYGNSS data set suggests that approximately 8.9% of all inland returns are coherent. Inland regions persistently identified as coherent were found largely to be associated with the presence of water bodies. A smaller set of desert locations apparently having very low surface roughness were also found to be associated with persistent coherence. The detector was also applied to a set of ocean measurements, with the results showing that persistent coherence is limited to areas with sheltered waters. Ocean tests avoiding such regions indicate that the detector's false-alarm rate is approximately 0.0012% for the detection threshold used.
6 March 2020 in IEEE Transactions on Geoscience and Remote Sensing
Ocean surface altimetry with GNSS reflectometry (GNSS-R) has the potential to improve the observation and retrieval of mesoscale ocean current flows by increasing the spatial density of ocean surface observations. The leading challenges in current GNSS-R altimetry investigations include precise delay retracking, correction of ionospheric effects, and spacecraft receiver positioning. Here, we present improved methods to account for these challenges. A reflection-model-based approach is presented for delay retracking that uses simulated delay-Doppler maps (DDMs) to retrieve the specular delay from measured DDMs. Global ionosphere maps are used to estimate the group delay effect along the direct and reflection paths. Precise orbit determination techniques are used to improve estimates of the receiving spacecraft position and reduce systematic intersatellite biases. We analyze altimetric height retrievals from two cases, strongly coherent or diffuse reflections. We study the residual systematic error signals with a focus on understanding the errors identified above. The strong coherent observations have narrow, symmetric delay waveforms and provide higher than average signal-to-noise ratio. The DDMs of diffuse observations, originate from relatively rough ocean surfaces and have the characteristic horse-shoe shape. Only measurements from the ocean and seas surrounding Indonesia are considered as this area provides a significant number of strongly coherent reflections. More than 50,000 single-point observations and week-long averaged results are presented to quantify the noise and systematic characteristics of the retrieved surface heights.
17 May 2023 in IEEE Transactions on Geoscience and Remote Sensing
When GNSS signals reflect off of the surfaces of lakes, rivers, wetlands, and other inland water bodies, the surfaces are often sufficiently smooth to produce coherent reflections. The observable produced from coherent reflections made by GNSS Reflectometry (GNSS-R) instruments exhibits particular features with respect to diffusely scattered signals by rough land and wind-driven oceans allowing detection of such smooth bodies. Several different GNSS-R coherence detection approaches have been reported in the literature and developed among the GNSS-R community over the last several years; however, the merits of each approach are difficult to compare because they are often applied to different scenarios and quantified in different ways, independently of each other. This paper provides a unified comparison of a wide variety of different GNSS-R coherence detection approaches, which is the most extensive published to date. The approaches are applied to a common data set from the NASA CYGNSS satellites that includes both the standard Level-1 DDM science product as well as raw baseband signal recordings. Additionally, simulated observables are generated with varying coherent and non-coherent reflection components to exercise algorithms over a wide range of SNRs and relative powers. Objective measures of accuracy are used to quantify the performance of each approach in the context of relative implementation complexity. Conclusions are presented on the pros/cons of the various methods as they relate to various applications such as real-time in-orbit coherence detection or post-processing on the ground.
27 February 2023 in IEEE Transactions on Geoscience and Remote Sensing
Recent results have highlighted the potential ability of bi- and multistatic synthetic aperture radar (SAR) tomographers to measure vegetation structure and surface topography. However, the quality of SAR tomographic measurements with multiple platforms is impacted by the phase instability in each platform’s oscillator. The phase noise, if uncompensated, may lead to degradation in the SAR data products such as increased sidelobe levels, reduced peak amplitude of the impulse response, and a low frequency phase modulation, among others. In this work, we model and examine the effects of oscillator phase noise on tomographic SAR signals for spaceborne missions flying in formation. A synchronization process is also adopted to help mitigate oscillator phase errors by measuring and predicting relative phase offsets at prescribed temporal intervals. A simulation tool was developed to examine the point target response as seen by realistic satellite constellations in low Earth orbit using different quality oscillators, radar configurations, and synchronization configurations. A first analysis of a multi-platform tomographic SAR mission suggests that a system without a dedicated physical link with minimal effects on the point target response may be achievable using current oscillators. Our analysis also shows that phase noise has differing effects on multistatic radar modes. Tomograms formed with a system operating in SIMO mode are the most affected by oscillator phase noise error, followed by MIMO, with negligible effects on the SAR-SISO mode. These trade studies and the simulation tool can be used to help inform the design of future multistatic radar missions.
9 July 2021 in Earth and Space Science
GNSS Reflectometry (GNSS‐R) measurements over inland water bodies, such as lakes, rivers, and wetlands exhibit strong coherent signals. The strength of the coherent reflections is highly sensitive to small‐scale surface roughness. For inland waters, this roughness is primarily due to wind‐driven surface waves. The sensitivity of the coherent reflections to surface roughness can be leveraged to estimate wave height profiles across inland waters. Coupled with a wind wave model, an approach to retrieve a wind vector is described using a forward model, which is potentially able to predict scattered power profiles for different wind speeds and directions and choosing the minimum‐squared error solution. The ability for spaceborne or airborne GNSS‐R to measure an inland water wind vector and wave heights could contribute to scientific applications focused on understanding nearshore ecosystems, monitoring climate change effects on inland waters, sediment resuspension, biomass production, fish habitat, and others. This paper presents a novel approach to potentially retrieve wind vector and wave heights over inland waters using GNSS‐R and discusses the issues with performing such retrievals using simulation and very few available raw signals recorded from CYGNSS satellites.
23 February 2026 in IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing
The location of water on the Earth's surface is critical for a wide range of science and application uses. Global Navigation Satellite System reflectometry (GNSS-R) is a remote sensing technique with demonstrated potential for identifying areas of the Earth's surface that are inundated, given that GNSS-R signals are sensitive to smooth surfaces, allowing for the detection of surface water. However, the signal is known to saturate even at relatively low quantities of surface water within an observational footprint, complicating the interpretation of GNSS-R observations. To date, the minimal detectable size of a water body within the GNSS-R signal footprint has remained elusive. This manuscript examines this sensitivity of one GNSS-R mission, the Cyclone Global Navigation Satellite System (CYGNSS), by using a high resolution surface water extent product as truth (Dynamic Surface Water Extent). This analysis reveals that for the Tonle Sap Lake region in Cambodia, the lower limit of water area detectable by CYGNSS was 0.62 $km^{2}$ of water surface area within a 0.05 degree grid cell, or 2% surface water cover. This finding indicates that at least for this region, a probabilistic interpretation of CYGNSS observations may be more appropriate than a binary classification. Such an interpretation establishes a foundation for synergistic use of CYGNSS GNSS-R with other surface water remote sensing technologies.