Rakesh Ramachandran

Rakesh Ramachandran

Auto-generated profile, based on publicly available information

Rakesh Ramachandran

Maersk Mc-Kinney Moller Institute, University of Southern Denmark, Odense, Denmark

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 September 2016 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
RRRakesh Ramachandran
Rakesh Ramachandran
MNMorten Nymand
Morten Nymand
This paper demonstrates the utilization of gallium nitride (GaN) devices to achieve an ultrahigh efficiency in an isolated dc-dc converter. This paper presents the design and implementation of high-efficiency magnetics necessary to realize such an ultrahigh efficiency converter. Synchronous rectification is also implemented to further improve the efficiency. Compared to an equivalent silicon MOSFET, GaN devices have low output charge, very low gate drive losses, and zero reverse recovery losses, this makes GaN devices more suitable for power converters to achieve high efficiency. A complete analytical loss modeling for an isolated full bridge dc-dc converter is discussed in this paper. Furthermore, the experimental demonstration of ultrahigh efficiency in a 2.4-kW isolated GaN converter is presented. Ultrahigh conversion efficiency allows the realization of a very compact dc-dc converter with a very small or no heat sink. The prototype converter has a power density of 7 kW/L and the measured efficiency is above 98.5% over a wide range of output power. The maximum measured efficiency of the converter is 98.8% at 50% of full load.

1 March 2016
Verified
Conference Paper
Closed access
RRRakesh Ramachandran
Rakesh Ramachandran
MNMorten Nymand
Morten Nymand
The paper presents the design and development of an ultra-high efficiency bidirectional isolated full bridge dc-dc converter using Gallium Nitride (GaN) devices. To achieve ultrahigh efficiency, GaN devices, synchronous rectification and high efficiency magnetics are used. The proposed bidirectional converter allows a power flow in both directions using the same power components; this increases power density and reduce the cost. The performance of a 1.7 kW bidirectional converter is experimentally validated in both forward direction (buck mode) and backward direction (boost mode). The converter operates at a switching frequency of 50 kHz with a voltage of 130V at one side and 52V at the other side of the converter. The fast switching speed of the GaN devices are utilized to achieve extremely high conversion efficiency thus reducing the total volume of the converter. The high power GaN converter has attained an extremely high efficiency of 98.8% in both the directions. This paper demonstrates the highest achievable conversion efficiency with the present technology.

1 November 2016
Verified
Conference Paper
Closed access
RRRakesh Ramachandran
Rakesh Ramachandran
MNMorten Nymand
Morten Nymand
In order to increase the power handling capability and to realize high efficiency in power converters, paralleling of GaN FETs are essential. This paper discusses the challenges in paralleling of GaN devices in an isolated full bridge dc-dc converter. When they are used for parallel operation, equal sharing of current should be ensured in the devices. A 2.4 kW isolated full bridge converter is developed with extensive paralleling of GaN devices. Current measurement in these devices is almost impossible due to their packaging as well as to avoid any parasitic impedance introduced into the circuit. An infra-red camera and the gate source voltage are used to analyze the sharing of current in these devices. Experimental results verify that the paralleled GaN FETs shares the current appropriately. The proposed converter has achieved a measured peak efficiency of 98.8% at 1.3 kW output power.

1 March 2015
Verified
Conference Paper
Closed access
RRRakesh Ramachandran
Rakesh Ramachandran
MNMorten Nymand
Morten Nymand
The paper presents the design and development of an ultra-high efficiency phase shifted full bridge isolated dc-dc converter using Gallium Nitride (GaN) devices. Synchronous rectification along with high efficiency magnetics and use of GaN devices contribute to the improvement in efficiency. In this paper, zero voltage switching is achieved by increasing the magnetizing current in the transformer and hence reduces the switching loss in the converter. The design and development of a 1 kW, 130V to 52V isolated dc-dc phase shifted GaN converter with a switching frequency of 50 kHz is presented in this paper. Furthermore, the design and analysis of high efficiency magnetics are discussed along with the experimental verification of the results. The maximum efficiency of the converter is measured to 98.8% at 80% of full load.

1 June 2015
Verified
Conference Paper
Closed access
RRRakesh Ramachandran
Rakesh Ramachandran
MNMorten Nymand
Morten Nymand
The paper presents the analysis of capacitive losses in GaN devices for an isolated full bridge dc-dc converter. The output capacitances of GaN device are responsible for a significant part of switching losses in a hard switched converter. Detailed knowledge of output capacitance losses is therefore important in the selection of optimum number of devices for a given power level. The analysis is performed on a 130V to 50V, 1.7 kW full bridge isolated dc-dc GaN converter operating at a switching frequency of 50 kHz. The paper also presents the measured efficiency curve of the GaN converter. The converter has attained a maximum measured efficiency of 98.7%.

1 September 2015
Verified
Conference Paper
Closed access
RRRakesh Ramachandran
Rakesh Ramachandran
MNMorten Nymand
Morten Nymand
The paper presents the detailed analysis of switching losses in GaN devices for an isolated full-bridge dc-dc converter. Switching losses includes capacitive losses along with turn-on and turn-off losses of the power MOSFET. In hard switched converters, the output capacitance of MOSFET contributes to a significant part of the switching loss. The capacitive loss analysis also helps in determining the optimum number of devices used in parallel for a given power level and switching frequency. The analysis is performed on a 1.7 kW full bridge isolated dc-dc GaN converter at a switching frequency of 50 kHz. The paper also presents the GaN switch efficiency curve for an isolated dc-dc GaN converter with different number of devices in parallel.