Center for Energy Resources Engineering, Department of Chemical and Biochemical Engineering, Technical University of Denmark, Kongens Lyngby 2800, Denmark
Auto-generated profile, based on publicly available information
Meng Shi
Center for Energy Resources Engineering, Department of Chemical and Biochemical Engineering, Technical University of Denmark, Kongens Lyngby 2800, Denmark
Efficiently and safely producing natural gas stored as gas hydrates remains an urgent and, as yet, unsolved challenge. CO2 replacement method is attractive for combining methane production and carbon dioxide storage but with low efficiency attributed to a barrier formed at interface between vapor and solid phase. Although there has been previous work in this area, development is restricted by the obscure underlying mechanism of improving recovery efficiency for long term. In this study, a series of experiments were conducted aiming to obtain new concept for improved recovery by the combination of depressurization and gas replacement method, in which air/CO2-enriched air were injected into artificial multilayer hydrate sediment at pressures ranges from 8.5 to 18.7 MPa. The recovery efficiency were investigated using a method that combines three stages depressurization assisted with CO2-enriched air injection. Initial production pressure was found have positive affect on recovery of methane via injecting of air, whilst an opposite influence by injecting CO2-enriched air. Compared with injecting air, injecting CO2-enriched air promotes the performance of gas hydrate production up to 74.4 % recovery ratio. A novel proposed multi-layer hydrate cap mechanism is therefore built to describe the improved efficiency during replacement-depressurization process for the first time. Multilayer hydrate cap and its composition are largely depended on initial condition of injected gas, thereby causing limited recovery efficiency. The results obtained from this study are beneficial for future optimizing operation conditions to maximize efficiency and develop planning for natural gas hydrate resources. The novelty and originality of the work are a proposed new multilayer hydrate cap mechanism and an improved recovery method for gas from hydrate layers.
The tire tread depth has strong influence on the braking performance of the vehicle and should be inspected periodically for driving safety. In order to determine the tire tread depth accurately and automatically, a tire tread depth measurement method based on machine vision was developed. During the measuring, a tire tread radial section image formed by a laser plane was captured when the tire rolls over the measuring device. Then, the image was calibrated to eliminate the lens distortion and processed to get the single-pixel center line. Consequently, the center line’s pixel coordinates were transformed to world coordinates with the calibration information of the laser plane, and a profile curve of the tire radial section was obtained. Then, the tread grooves on the profile curve were identified and their positions are determined by an algorithm developed in this research. Finally, the depth of each groove was calculated successively. An experiment was conducted on a prototype system based on the measurement method developed in this article. The experimental result indicates that the measurement method can identify the tire tread groove and determine its position and measure its depth. The depth absolute error is less than 0.2 mm, which can meet the demand of tire tread depth measurement.