18 June 2021 in IEEE Transactions on Circuits and Systems I: Regular Papers
This paper presents a transimpedance-to-noise optimization approach for design of a resistive shunt-feedback TIA. This optimization offers an enhancement in the transimpedance and a noise performance very close to the theoretical minimum noise of the TIA. In addition, the transimpedance-to-noise optimization approach results in a small front-end FET size which enables a further reduction in power and area. Moreover, this approach enables using a fewer number of stages in the receiver chain which makes a high PSRR feasible and obviates the necessity for using an offset cancellation circuitry. Building on this approach, a fully differential analog front-end including a resistive shunt-feedback TIA and a post amplifier (PA) for time-of-flight (ToF) Lidar receivers is designed and implemented, achieving 94dB Ω transimpedance gain, 71nA input-referred rms noise current, -3dB bandwidth of 340MHz, and power supply rejection ratio (PSRR) of more than 87dB in a 0.11 μm CMOS process. The associated DC power consumption is 19.4mW with V DD of 1.8V. Moreover, a push-pull buffer with 1V output swing is integrated for driving 50 Ω loads, such as off-chip time discriminators, which also additionally amplifies the signal with a gain of 5dB while consuming an extra 20.9mW of DC power. The whole chip (excluding pads) occupies 210 μm × 110 μm in area.
20 August 2020 in IEEE Solid-State Circuits Letters
In this paper, a low cost, compact, and systematic method for generating a short pulse and efficiently delivering it to low impedance loads is proposed. The load can be a resistive on-chip or off-chip load, an antenna, or another stage such as a power combiner. The technique is inspired by time domain reflectometry from a short-circuited termination. The technique is fully compatible with CMOS technology. To show the feasibility of the idea, two chips are fabricated and tested in a low cost 0.11 μm CMOS process with fT≈80GHz. The full width at half maximum (FWHM) of the pulses are 6.8 ps and 8.8 ps, and the amplitudes over a 50 Ω load are 0.62 V and 1 V. Either of the chips occupies 1160×540 μm2 in area.