To address the growing demand for energy and support the shift toward transportation electrification and intermittent renewable energy, there is an urgent need for low‐cost, energy‐dense electrical storage. Research on Li‐ion electrode materials has predominantly focused on ordered materials with well‐defined lithium diffusion channels, limiting cathode design to resource‐constrained Ni‐ and Co‐based oxides and lower‐energy polyanion compounds. Recently, disordered rocksalts with lithium excess (DRX) have demonstrated high capacity and energy density when lithium excess and/or local ordering allow statistical percolation of lithium sites through the structure. This cation disorder can be induced by high temperature synthesis or mechanochemical synthesis methods for a broad range of compositions. DRX oxides and oxyfluorides containing Earth‐abundant transition metals have been prepared using various synthesis routes, including solid‐state, molten‐salt, and sol‐gel reactions. This review outlines DRX design principles and explains the effect of synthesis conditions on cation disorder and short‐range cation ordering (SRO), which determines the cycling stability and rate capability. In addition, strategies to enhance Li transport and capacity retention with Mn‐rich DRX possessing partial spinel‐like ordering are discussed. Finally, the review considers the optimization of carbon and electrolyte in DRX materials and addresses key challenges and opportunities for commercializing DRX cathodes.
This research work focuses on machine-learning-assisted prediction of the corrosion behavior of laser-powder-bed-fused (LPBF) and postprocessed Inconel 718. Corrosion testing data of these specimens were collected and fit into the following machine learning algorithms: polynomial regression, support vector regression, decision tree, and extreme gradient boosting. The model performance, after hyperparameter optimization, was evaluated using a set of established metrics: R2, mean absolute error, and root mean square error. Among the algorithms, the extreme gradient boosting algorithm performed best in predicting the corrosion behavior, closely followed by other algorithms. Feature importance analysis was executed in order to determine the postprocessing parameters that influenced the most the corrosion behavior in Inconel 718 manufactured by LPBF.
20 January 2026 in Journal of the American Chemical Society
Electrolytes for extreme fast charging (XFC) of Li-ion batteries must combine high ionic conductivity with favorable Li+ transference, yet these transport properties are difficult to improve simultaneously in practical carbonate-based liquids. Here, we investigate a 1.2 M LiPF6 electrolyte series based on ethylene carbonate (EC), ethyl methyl carbonate (EMC), and acetonitrile (ACN), in which ACN progressively replaces EMC from 0 to 40 vol%. Experiment and molecular dynamics (MD) simulations show that increasing ACN content raises conductivity from ∼10 to 23 mS cm−1, lowers viscosity from 3.5 to 2.2 cP, while MD further predicts a modest increase in the Li+ transference number from 0.37 to 0.42. These transport gains exceed what is expected from viscosity reduction alone: the conductivity–viscosity product increases monotonically, whereas ionicity and ion pair fractions change only weakly. At the molecular level, not only does ACN replace EMC in the Li+ first solvation shell, it remarkably shortens the residence time of all solvation shell species, thereby increasing solvation shell lability. Onsager analysis shows that ACN enhances the transport of both Li+ and PF− 6 while reducing persistent Li+–PF− 6 correlated motion over transport-relevant times. Solvent-resolved correlations and PF− 6 entry/exit analyses further show that ACN promotes faster solvent exchange during local ion-pair formation and relaxation, shifting transport away from a more vehicular regime and toward a more exchange-mediated one. These results identify dynamic solvent tuning as a transport design principle for XFC-relevant electrolytes, showing that the experimental measurements of conductivity and cation transference can be improved without requiring a major change in ion association.