28 April 2015 in International Journal of Heat and Mass Transfer
14 September 2020 in Journal of Turbomachinery
1 July 2019 in International Journal of Heat and Mass Transfer
3 October 2020 in Heat and Mass Transfer
28 December 2021 in Journal of Microelectromechanical Systems
Micropumps are microelectromechanical system (MEMS) devices that pump small quantities of liquids. They are used in many applications such as electronics cooling and drug delivery. Valveless fluid diode micropumps with no moving parts have recently attracted great interest in the MEMS community. In this paper, topology optimization is used to design two-dimensional, fixed-geometry, fluidic diodes of high diodicity, which is the ratio of pressure drops of forward to reverse flows. One of the fluidic diodes, of the Tesla type, shows a diodicity of over five. Another is of the nozzle-diffuser type. Both are experimentally and computationally demonstrated herein. Then the numerical simulation was applied to simplify the structures, and the two-dimensional geometry was converted into three-dimensional model for micropumps. Three-dimensional and unsteady numerical analyses of micropump fluid flow with optimized diodes were conducted for pumps of each of the two diode designs. The micropump with the Tesla-type fluidic diode reached a measured flow rate of 34 ml/h, consistent with the computed results and 2.2 times that of the nozzle-diffuser type micropump. The performance results show a high dependence on internal channel geometry. The two types show highest flow rates with an internal channel thickness of $200 ~\mu \text{m}$ . Demonstrated good repeatability and precise flow control show positive prospects for application. [2021-0144]
17 September 2017 in Numerical Heat Transfer, Part A: Applications
This numerical study investigates turbulent flow characteristics and heat transfer augmentation in a rectangular channel with elliptical cylinders and protrusions. The height of protrusions is changed to quantify interactions with surrounding elliptical cylinders. Flow structures, temperature distributions, and heat transfer characteristics are obtained with a standard k − ε turbulence closure model. Cases are run at Reynolds numbers of 15,000 and 20,000. Combinations of protrusion and elliptical cylinder geometries give higher heat transfer rates than a case without protrusions. Additionally, Nusselt numbers increase with increases in height of protrusions and an optimum height-to-footprint diameter ratio is found.