6 May 2014 in Magnetic Resonance in Chemistry
Hyperpolarization methods are used in NMR to overcome its inherent sensitivity problem. Herein, the biologically relevant target nicotinamide is polarized by the hyperpolarization technique signal amplification by reversible exchange. We illustrate how the polarization transfer field, and the concentrations of parahydrogen, the polarization‐transfer‐catalyst and substrate can be used to maximize signal amplification by reversible exchange effectiveness by reference to the first‐order spin system of this target. The catalyst is shown to be crucial in this process, first by facilitating the transfer of hyperpolarization from parahydrogen to nicotinamide and then by depleting the resulting polarized states through further interaction. The 15 longitudinal one, two, three and four spin order terms produced are rigorously identified and quantified using an automated flow apparatus in conjunction with NMR pulse sequences based on the only parahydrogen spectroscopy protocol. The rates of build‐up of these terms were shown to follow the order four~three > two > single spin; this order parallels their rates of relaxation. The result of these competing effects is that the less‐efficiently formed single‐spin order terms dominate at the point of measurement with the two‐spin terms having amplitudes that are an order of magnitude lower. We also complete further measurements to demonstrate that 13C NMR spectra can be readily collected where the long‐lived quaternary 13C signals appear with significant intensity. These are improved upon by using INEPT. In summary, we dissect the complexity of this method, highlighting its benefits to the NMR community and its applicability for high‐sensitivity magnetic resonance imaging detection in the future. © 2014 The Authors. Magnetic Resonance in Chemistry by John Wiley & Sons, Ltd.
26 March 2013 in Analytical Chemistry
17 July 2015 in Journal of the American Society for Mass Spectrometry
1 February 2016 in Journal of Proteomics
18 March 2005 in The Analyst
The use of two methods in tandem, single-sided membrane introduction mass spectrometry (SS-MIMS) and fiber introduction mass spectrometry (FIMS), is presented as a technique for field analysis. The combined SS-MIMS-FIMS technique was employed in both a modified commercial mass spectrometer and a miniature mass spectrometer for the selective preconcentration of the explosive simulant o-nitrotoluene (ONT) and the chemical warfare agent simulant, methyl salicylate (MeS), in air. A home-built FIMS inlet was fabricated to allow introduction of the solid-phase microextraction (SPME) fiber into the mass spectrometer chamber and subsequent desorption of the trapped compounds using resistive heating. The SS-MIMS preconcentration system was also home-built from commercial vacuum parts. Optimization experiments were done separately for each preconcentration system to achieve the best extraction conditions prior to use of the two techniques in combination. Improved limits of detection, in the low ppb range, were observed for the combination compared to FIMS alone, using several SS-MIMS preconcentration cycles. The SS-MIMS-FIMS response for both instruments was found to be linear over the range 50 to 800 ppb. Other parameters studied were absorption time profiles, effects of sample flow rate, desorption temperature, fiber background, memory effects, and membrane fatigue. This simple, sensitive, accurate, robust, selective, and rapid sample preconcentration and introduction technique shows promise for field analysis of low vapor pressure compounds, where analyte concentrations will be extremely low and the compounds are difficult to extract from a matrix like air.