21 September 2022 in Optics Express
Aluminum-rich p-AlGaN electron blocking layers (EBLs) are typically used for preventing overflow of electrons from the active region in AlGaN-based deep ultraviolet (DUV) laser diode (LD). However, these cannot effectively prevent electron leakage and form barrier layers, which affects the hole injection efficiency. Herein, the traditional p-AlGaN EBL in LD is replaced with an undoped BGaN EBL. The undoped BGaN EBL LD increases the effective barrier height of the conduction band to prevent the leakage of electrons and decreases the energy loss caused by the polarization induced electric field, enhancing the hole injection. The slope efficiency of the undoped BGaN EBL LD is 289% higher than that of the highly doped AlGaN EBL LD, and its threshold current is 51% lower. Therefore, the findings of this study provide insights for solving the problems of electron leakage and insufficient hole injection in high-performance and undoped EBL DUV LDs.
6 March 2024 in Optics Express
The superlattice electron blocking layer (EBL) has been proposed to reduce the electron leakage of the deep ultraviolet light emitting diodes (DUV-LEDs). However, the hole transport is hindered by the barriers of EBL and the improvement of hole injection efficiency still suffers enormous challenges. The superlattice step doped (SLSD) EBL is proposed to improve the hole injection efficiency while enhancing the electron confinement capability. The SLSD EBL enhances the electron confinement capability by multi-reflection effects on the electron wave function. And a built-in electric field towards the active region is generated by superlattice step doping, which facilitates the transport of holes into the multiple quantum wells. The Advaced Physical Model of Semiconductor Devices (APSYS) software is used to simulate the DUV-LEDs with conventional EBL, superlattice EBL, superlattice doped EBL, and SLSD EBL. The results indicate that the SLSD EBL contributes to the increased electron concentration in the multiple quantum wells, the reduced electron leakage in the p-type region, the increased hole injection current, and the increased radiative recombination rate. When the current is 60 mA, the external quantum efficiency of DUV-LED with SLSD EBL is increased to 5.27% and the output power is increased to 13.81 mW. The SLSD EBL provides a valuable reference for solving the problems of serious electron leakage and insufficient hole injection of the DUV-LEDs.
2 August 2024 in Scientific Reports
The deep ultraviolet (DUV) micro-light emitting diode (μLED) has serious electron leakage and low hole injection efficiency. Meanwhile, with the decrease in the size of the LED chip, the plasma-assisted dry etching process will cause damage to the side wall of the mesa, which will form a carrier leakage channel and produce non-radiative recombination. All of these will reduce the photoelectric performance of μLED. To this end, this study introduces polarized bulk charges into the hole supply layer (p-HSL) and the electron supply layer (n-ESL) respectively (dual-polarized structure) of the DUV μLED at an emission wavelength of 279 nm to enhance the binding of carriers and increase the injection efficiency of carriers. This is because the polarization-induced bulk charge can shield the polarized sheet charge on the interface and reduce the polarization electric field. The reduced polarization electric field in p-HSL can increase the effective barrier height of the conduction band in the p-type region and reduce the effective barrier height of the valence band. The decrease in the polarized electric field of n-HSL can reduce the thermal velocity of electrons, thereby enhancing the electron injection efficiency, reducing the Shockley–Read–Hall (SRH) recombination, and increasing the effective barrier height of the valence band. The study results indicate that the electron concentration and hole concentration of a μLED with dual polarization were increased by 77.93% and 93.6%, respectively. The optical power and maximum external quantum efficiency of μLED reached 31.04 W/cm2 and 2.91% respectively, and the efficiency droop is only 2.06% at 120 A/cm2. These results provide a new approach to solving the problem of insufficient carrier injection and SRH recombination in high-performance DUV μLEDs.
11 October 2022 in Applied Physics B
6 March 2024 in Optics Express
While traditional tunnel junction (TJ) light-emitting diodes (LEDs) can enhance current diffusion and increase hole injection efficiency, their reliance on highly doped AlGaN layers to improve hole tunneling efficiency results in a higher conduction voltage, adversely impacting LED device performance. This paper proposes a non-heavy doped pnp-AlGaN TJ deep ultraviolet (DUV) LED with a low conduction voltage. By inserting the TJ near the active region, between the electron blocking layer and the hole supply layer, the need for heavily doped AlGaN is circumvented. Furthermore, the LED leverages the polarization charge in the pnp-AlGaN TJ layer to decrease the electric field strength, enhancing hole tunneling effects and reducing conduction voltage. The non-heavy doped pnp-AlGaN TJ LED effectively enhances carrier concentration in the quantum well, achieving a more uniform distribution of electrons and holes, thus improving radiative recombination efficiency. Consequently, at an injection current of 120 A/cm2, compared to the traditional structure LED (without TJ), the proposed LED exhibits a 190.7% increase in optical power, a 142.8% increase in maximum internal quantum efficiency (IQE) to 0.85, and a modest efficiency droop of only 5.8%, with a conduction voltage of just 4.1V. These findings offer valuable insights to address the challenges of high heavy doped TJ and elevated conduction voltage in high-performance TJ DUV LEDs.
17 June 2024 in Applied Physics B