Nataliia Golub

Nataliia Golub

Auto-generated profile, based on publicly available information

Nataliia Golub

Igor Sikorsky Kyiv Polytechnic Institute, Kyiv

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 March 2014 in Journal of Water Chemistry and Technology
Verified
Journal Article
Closed access
PDF file
NGN. B. Golub
N. B. Golub
ESE. A. Shchurskaya
E. A. Shchurskaya
MTM. V. Trotsenko
M. V. Trotsenko
Processes of brewery wastewater treatment with sequential use of the fermentative and bioelectrochemical methods have been investigated. A two-stage fermentation increases the rate of substrate utilization and hydrogen production. The water treatment efficiency in terms of COD in the first and second fermenters amounts to 55–65% and 65–72%, respectively. The hydrogen concentration in biogas can reach 65%. The organic acids produced in anaerobic fermentation process represent a substrate for exoelectrogenic microorganisms of bioelectrochemical fuel cell, where the secondary wastewater treatment takes place for achieving COD values of 200–400 mg/dm3. The combination of the fermentative and bioelectrochemical processes of hydrogen production makes it possible to increase its yield by a factor of 2–4 and reach the level of 7–9 moles of H2 per 1 mole of glucose.

11 April 2016 in Eastern-European Journal of Enterprise Technologies
Verified
Journal Article
Open access
PDF file
NGNatalia Golub
Natalia Golub
ILIgor Levtun
Igor Levtun
The urgency of the problem is to determine the parameters of the external factor, the effect of which on Chlorella vulgaris cells increases the biosynthesis of triacylglycerols – feedstock for biodiesel production without reducing the biomass growth rate. The purpose of the paper is to determine the impact of sound irradiation on Chlorella vulgaris metabolism and biomass growth. Cultivation was carried out in the Gromov 6 medium at a temperature of 18 ± 20С. The effect of sound irradiation with frequencies of 5, 10, 15 and 20 kHz, power of 5 W/cm2 on the yield of lipids and biomass is investigated. It is shown that ultrasound irradiation with a frequency of 20 kHz increases the growth of biomass by 10% and lipids by 3 times compared to non–irradiated cells. This irradiation frequency is optimum among the studied frequencies to be used as a factor of influence for biodiesel production from Chlorella vulgaris microalgae. Irradiation with sound spectrum frequencies affects the cell metabolism towards increased biosynthesis of lipids. The specific content of the lipid fraction exceeds its content in non–irradiated cells by 1.5, 2.1 and 2 times for frequencies of 15, 10 and 5 kHz, respectively. At the same time, irradiation of microalgae cells with frequencies of 10 and 15 kHz reduces the biomass growth by 10±1 % compared to the control sample.

22 January 2024 in Innovative Biosystems and Bioengineering
Verified
Journal Article
Open access
PDF file
NGNataliia Golub
Nataliia Golub
LZLiudmyla Zubchenko
Liudmyla Zubchenko
IDIryna Demianenko
Iryna Demianenko
YZYumei Zhang
Yumei Zhang
NSNataliia Seminska
Nataliia Seminska
Background. In the last decades, humanity has faced the challenge of finding new ways to obtain renewable, environmentally friendly energy carriers. Hydrogen is one of such energy carriers; however, the current methods of its production require fossil fuels and are accompanied by significant CO2 emissions. Consequently, the energy costs needed to obtain hydrogen by electrolysis exceed the amount of energy produced by burning the hydrogen. Simultaneously, the hydrogen yields for alternative ways, such as fermentation, remain low. Objective. The aim of the work is the development of approaches to intensify the biohydrogen obtaining process from agricultural waste. Methods. An increase in hydrogen yield was achieved using specifically grown microorganisms of the Clostridium spp. A combination of the waste fermentation process with the production of hydrogen in a microbial fuel cell (MFC), which was fed with the liquid fraction after fermentation, was employed. Results. The yield of hydrogen depends on the component composition of the raw material. Higher lignin content in the raw material reduces the yield of hydrogen. The addition of Clostridium spp. to the natural consortium in the amount of 10% of the total inoculum led to an increase in hydrogen yield. The combination of two processes – fermentation and hydrogen production in a MFC – increased the yield of hydrogen by 1.7 times, along with a higher degree of organic raw materials utilization. Conclusions. The additional introduction of Clostridium spp. to the hydrogen-producing consortium leads to a 7–10% increase in the yield of hydrogen, depending on the composition of the raw material. The yield of hydrogen obtained in the fermentation process for the substrate containing corn silage is 12 ± 1% higher than for the wheat straw. In general, the combination of the fermentation and hydrogen production in the MFC in a two-stage process leads to an overall increase in the yield of hydrogen by 60 ± 5%.

16 August 2020 in Water, Air, & Soil Pollution
Verified
Journal Article
Closed access
PDF file
NGN. B. Golub
N. B. Golub
MSM. V. Shinkarchuk
M. V. Shinkarchuk
OKO. A. Kozlovets
O. A. Kozlovets
BMB. V. Morgun
B. V. Morgun
OLOlha Lakhneko
Olha Lakhneko
MBM. V. Borisjuk
M. V. Borisjuk

6 May 2019 in Innovative Biosystems and Bioengineering
Verified
Journal Article
Open access
NGNataliia Golub
Nataliia Golub
MPMariana Potapova
Mariana Potapova
YKYuriy Karpenko
Yuriy Karpenko

16 February 2022 in Innovative Biosystems and Bioengineering
Verified
Journal Article
Open access
PDF file
AYAngelina Yurchenko
Angelina Yurchenko
NGNataliia Golub
Nataliia Golub
LJLi Jinping
Li Jinping
Background. The ever-increasing demand for plastic polymer products with simultaneous depleting fossil fuels such as oil and natural gas, as well as the growing problem of waste disposal, creates a need to find alternative technologies that meet current trends in both environmental and economic development. Bioplastic materials that are synthesized from renewable sources and have the ability to biodegrade are considered as such an alternative. The main obstacle of modern bioplastics which makes it impossible to completely replace traditional plastics is the high cost of production. In order to reduce the cost of existing biopolymers, production waste is added to the polymer matrix. One such waste is lignin – the second most common biopolymer. An additional way to reduce the cost of production is to find more cost-effective producers. Thus, although the classical microbial synthesis has fairly high productivity, the source of carbon for the cultivation of microorganisms are sugars obtained from agricultural raw materials which could cause a threat for food industry. The new producer for production of polyhydroxyalkanoates (PHA) is cyanobacteria, the carbon source of which is carbon (IV) oxide or gas emissions from enterprises, which reduces the cost of the target product. Objective. Development of a method for obtaining bioplastics using products of microbial synthesis and lignin. Methods. Cyanobacteria Nostoc commune was grown using a nutrient medium BG-11 with subsequent limitation of Nitrogen for the synthesis of PHA. Hydrolyzed lignin from hardwoods was combined with polylactic acid (PLA) or cyanobacteria-synthesized PHA in different ratios with further casting of the solution to determine the ability of lignin and polymer matrix to form polymer films. Results. The content of PHA in the cells of cyanobacteria Nostoc commune, when grown in a nutrient medium limited to Nitrogen, reached 7.8%. The synthesized polymer films based on PLA and lignin were not homogeneous, and films based on PHA and lignin were fragile. Conclusions. The possibility of obtaining PHA by using cyanobacteria of the Nostoc commune species under environmental conditions that differ from the optimal ones for both cultivation and PHA production is shown. The possibility of obtaining a biopolymer based on lignin and PLA is shown. To form homogeneous films, it is necessary to change the standard conditions for obtaining a mixture of components. The interaction of lignin with PHA forms a homogeneous polymer mixture, which is fragile and requires the addition of plasticizers to obtain the necessary properties.