This paper provides a feasible way to suppress flame flickering under normal gravity and atmospheric pressure without changing the fuel mass burning rate, thus promoting steady-state combustion. By periodically reciprocating one burner horizontally in a dual burner system, a death mode (namely, amplitude death of flame height oscillation) is generated around the critical burner separation distance, which is a transition point between in-phase and antiphase flickering modes of the two flames. The criterion to obtain a complete death mode region in a general dual burner system (with horizontal movement function) is defined by two dimensionless parameters, which respectively quantify the burner configuration and its dynamic performance.
23 September 2022 in Proceedings of the Combustion Institute
Partially deuterated telluric acid ammonium phosphate (TAAP) single crystals were grown from water solutions with various H2O and D2O ratios. The transition temperature TC was determined from the dielectric anomaly characteristic to the second order phase transition. Deuteration molar fraction xc in the crystal was determined by a mass spectrograph. It was proved that TC increases almost linearly with xc. The maximum transition temperature reached 357 K for xc = 0.73. The deuteration effect in TAAP is clearly smaller than that in the typical hydrogen-bonded ferroelectrics such as KDP-type but considerably larger than TGS-type ferroelectrics.
This paper reports experimentally observed characteristics of smoldering and flaming spread along a cellulosic combustible solid. A thin cylindrical sample was burned in a forced oxidizer flow, and quasi-steady, downward opposed-flow spread was observed. The oxidizer velocity and the oxygen concentration were varied, and the spread velocity and the surface temperature were measured. The results indicated that the maximum surface temperature was a key quantity that controls the combustion mode, i.e., smoldering or flaming.