5 August 2022 in Journal of Petroleum Science and Engineering
MYMuhammad Aslam Md Yusof
26 February 2019 in International Journal of Chemical Engineering
Application of carbon nanomaterials in oil well drilling fluid has been previously studied and was found to enhance its filtration properties. There is a general consensus that addition of colloids in suspension will alter its rheology, i.e., carbon nanomaterials, in this research work; graphene nanoplatelets are hydrophobic materials, which require functionalisation to improve its dispersion in aqueous solution. However, different degrees of dispersion may vary the rheological properties behaviour of drilling fluid. The objective of this study was to characterize the colloidal dispersion of graphene nanoplatelets (GNP) in aqueous solution and its impact on the rheological properties behaviour of water-based drilling fluid. Dispersion of graphene nanoplatelets was achieved through noncovalent functionalisation by means of surfactant attachment. UV-visible spectroscopy was employed to analyze the dispersion of GNP in aqueous solution. The rheological test was carried out using a simple direct-indicating viscometer at six different speeds. Results revealed that the degree of dispersion of GNP using Triton X-100 was generally higher than both SDS and DTAB. Comparison between the rheological properties behaviour of drilling fluid with GNP dispersed using different surfactants shows little to no difference at low shear rates. At high shear rates, however, greater dispersion of GNP shows higher thinning properties while fluid with a low dispersion of GNP exhibited linear behaviour to thickening properties.
4 March 2019 in International Journal of Chemical Engineering
The higher cost of chemical surfactants has been one of the main reasons for their limited used in enhanced oil recovery (EOR) process. Hence, the reason for developing lignin-based surfactant is to lower the cost of chemicals as it does not tie to the price of crude oil as compared to petroleum-based surfactants. Besides, lignin is biodegradable and easily extracted from plant waste. The objectives of this study are to determine the formulations of the lignin-based surfactant for EOR applications and to determine the oil recovery performance of the formulated surfactants through surfactant flooding. The lignin-based surfactants were formulated by mixing the lignin with the amine (polyacrylamide or hexamethylenetetramine) and the surfactant sodium dodecylbenzenesulfonate in a 20,000 ppm NaCl brine. Interfacial tension (IFT) of the formulated lignin-based surfactant is measured at ambient temperature using the spinning drop method. The displacement experiments were conducted at room temperature in glass beads pack holders filled with glass beads, saturated with paraffin and brine. The results of the study showed that the best formulation of lignin-based surfactant is using hexamethylenetetramine as the amine, lignin, and sodium dodecylbenzenesulfonate at 2% total active concentration. The oil recovery and interfacial tension using the lignin amine system is comparable with the commercial petroleum sulfonate system.
2 May 2023 in Geoenergy Science and Engineering
MYMuhammad Aslam Md Yusof
+1