Matthew Gaddes

Matthew Gaddes

Auto-generated profile, based on publicly available information

Matthew Gaddes

COMET University of Leeds Leeds UK

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 November 2018 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Open access
PDF file
MGM. E. Gaddes
M. E. Gaddes
AHAndrew Hooper
Andrew Hooper
MBM. Bagnardi
M. Bagnardi
HIH. Inman
H. Inman
FAFabien Albino
Fabien Albino
There are some 1,500 volcanoes with the potential to erupt, but most are not instrumentally monitored. However, routine acquisition by the Sentinel‐1 satellites now fulfils the requirements needed for interferometric synthetic aperture radar (InSAR) to progress from a retrospective analysis tool to one used for near‐real‐time monitoring globally. However, global monitoring produces vast quantities of data, and consequently, an automatic detection algorithm is therefore required that is able to identify signs of new deformation, or changes in rate, in a time series of interferograms. On the basis that much of the signal contained in a time series of interferograms can be considered as a linear mixture of several latent sources, we explore the use of blind source separation methods to address this issue. We consider principal component analysis and independent component analysis (ICA) which have previously been applied to InSAR data and nonnegative matrix factorization which has not. Our systematic analysis of the three methods shows ICA to be best suited for most applications with InSAR data. However, care must be taken in the dimension reduction step of ICA not to remove important smaller magnitude signals. We apply ICA to the 2015 Wolf Volcano eruption (Galapagos Archipelago, Ecuador) and automatically isolate three signals, which are broadly similar to those manually identified in other studies. Finally, we develop a prototype detection algorithm based on ICA to identify the onset of the eruption.

28 November 2019 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Open access
PDF file
MGM. E. Gaddes
M. E. Gaddes
AHAndrew Hooper
Andrew Hooper
MBM. Bagnardi
M. Bagnardi
The latest generation of synthetic aperture radar satellites produce measurements of ground deformation at the majority of the world's subaerial active volcanoes and can be used to detect signs of volcanic unrest. We present an automatic detection algorithm that uses these data to automatically warn when deformation at a volcano departs from the background. We demonstrate our approach on synthetic data sets and the unrest leading to the 2018 eruption of Sierra Negra (Galapagos). Our algorithm encompasses spatial independent component analysis and uses a significantly improved version of the ICASO algorithm, which we term ICASAR, to robustly perform spatial independent component analysis. We use ICASAR to isolate signals of geophysical interest from atmospheric signals, before monitoring the evolution of these signals through time in order to detect the onset of a period of volcanic unrest.

17 June 2024 in Earth and Space Science
Verified
Journal Article
Open access
MGM. Gaddes
M. Gaddes
AHAndrew Hooper
Andrew Hooper
FAFabien Albino
Fabien Albino
With the evolution of interferometric synthetic aperture radar into a tool for active hazard monitoring, new methods are sought to quickly and automatically interpret the large number of interferograms that are created. We present a convolutional neural network (CNN) that is able to both classify the type of deformation, and to locate the deformation within an interferogram in a single step. We achieve this through building a “two headed model,” which returns both outputs after one forward pass of an interferogram through the network. We train our model by first creating a data set of synthetic interferograms, but find that our model's performance is improved through the inclusion of real Sentinel‐1 data. We also investigate how model performance can be improved by best organizing interferograms such that they can exploit the three channel nature of computer vision models trained on very large databases of labeled color images, but find that using different data in each of the three input channels degrades performance when compared to the simple case of repeating wrapped or unwrapped phase across each channel. We also release our labeled Sentinel‐1 interferograms as a database named VolcNet, which consists of ∼500,000 labeled interferograms. VolcNet comprises of time series of unwrapped phase and labels of the magnitude, location, and duration of deformation, which allows for the automatic creation of interferograms between any two acquisitions, and greatly increases the amount of data available compared to other labeling strategies.

9 December 2022 in Journal of Geophysical Research: Planets
Verified
Journal Article
Open access
ATA. R. Turner
A. R. Turner
JHJ. C. Hawthorne
J. C. Hawthorne
MGM. Gaddes
M. Gaddes
We probe the present‐day stresses in the lunar interior by examining the slip directions of moonquakes in the A01 nest. In this nest, some deep moonquakes appear to slip “backwards,” in the opposite direction to other events. We assess whether these changes in slip direction result from a spatial variation in the tectonic stress or from a temporal variation in the tidal stress. To test these two options, we first show that a dominant tectonic stress implies deep moonquakes can only slip in one direction: forwards and backwards, while a dominant tidal stress could allow moonquakes to slip in more directions: any combination of forwards, backwards, left, and right. Then we look for the number of slip directions; we separate the deep moonquake waveforms into slip directions using a principal component analysis technique. We find two slip directions present in the A01 deep moonquake nest. The moonquakes slip in a variety of directions as time evolves. This observation implies that the tidal stresses drive deep moonquakes. Additionally, these results place a new constraint on the magnitude of the tectonic stresses at depth; they must be smaller than the modeled tidal stress of ∼0.1 MPa.

1 July 2018
Verified
Conference Paper
Open access
AHAndrew Hooper
Andrew Hooper
TWTim Wright
Tim Wright
KSKarsten Spaans
Karsten Spaans
JEJohn Elliott
John Elliott
JWJonathan R. Weiss
Jonathan R. Weiss
JBJuliet Biggs
Juliet Biggs
Sentinel-1 represents a major step forward in enabling us to monitor the Earth's hazardous tectonic and volcanic zones. Here, we present the latest progress from the Centre for the Observation and Modelling of Earthquakes, Volcanoes and Tectonics (COMET), where we provide deformation results to the community for volcanoes and the tectonic belts. For the estimation of seismic hazard, we require relative accuracy on the order of 1 mm/yr between points 100 km apart. This requires mass processing of long time series of radar acquisitions. As of January 2018, we are producing in-terferograms systematically for the entire Alpine-Himalayan belt (~9000 × 2000 km) and the majority of subaerial volcanoes. Currently we make interferograms and coherence products available to the community, but we plan to also provide average deformation rates and displacement time series, in the future. The results are made available through a dedicated COMET portal, and we are in the process of linking them to the ESA G-TEP and EPOS. COMET also responds routinely to significant continental earthquakes, larger than ~Mw 6.0. The short repeat interval of Sentinel-1, together with the rapid availability of the data, allows us to do this within a few days for most earthquakes. For example, after the Mw 7.8 Kaikoura earthquake we supplied a processed interferogram to the community just 5 hours and 37 minutes after the Sentinel-1 acquisition. In this paper we provide an overview of some of the latest results for tectonics and volcanism and discuss how the accuracy of these products will improve as the number of data products acquired by Sentinel-1 increases.

5 May 2022 in ESS Open Archive
Verified
Preprint
Open access
ATAlice R Turner
Alice R Turner
JHJessica Cleary Hawthorne
Jessica Cleary Hawthorne
MGMatthew Gaddes
Matthew Gaddes
We probe the present-day stresses in the lunar interior by examining the slip directions of moonquakes in the A01 nest. In this nest, some deep moonquakes appear to slip ‘backwards’, in the opposite direction to other events. We assess whether these changes in slip direction result from a spatial variation in the tectonic stress or from a temporal variation in the tidal stress. To test these two options, we first show that a dominant tectonic stress implies deep moonquakes can only slip in one direction: forwards and backwards, while a dominant tidal stress could allow moonquakes to slip in more directions: any combination of forwards, backwards, left, and right. Then we look for the number of slip directions; we separate the deep moonquake waveforms into slip directions using a principal component analysis technique. We find two slip directions present in the A01 deep moonquake nest. The moonquakes slip in a variety of directions as time evolves. This observation implies that the tidal stresses drive deep moonquakes. Additionally, these results place a new constraint on the magnitude of the tectonic stresses at depth; they must be smaller than the modelled tidal stress of ~ 0.1 MPa.