Orbitronics provides novel mechanisms to generate terahertz (THz) emission using the orbital angular momentum of electrons. Here, we report a systematic investigation of the THz emission from Ni / Cu O x heterostructures pumped by a femtosecond laser pulse. Despite the very weak spin-orbit coupling of Cu O x , considerable THz radiation from Ni / Cu O x has been observed, with a polarity state that is magnetically controllable and the intensity as much as about 20% of that found in Ni/Pt spintronic THz emitter. We find conclusive evidence that THz radiation stems from the inverse orbital Rashba-Edelstein effect at the Ni / Cu O x interface, which can be manipulated by tuning oxygen-induced orbital hybridization. Our experimental results of Ni thickness-dependent THz emission, combined with theoretical modeling, reveal long-range diffusion-length characteristics of orbital current within the Ni layer. This work enhances the understanding of the THz emission mechanism based on orbital-to-charge conversion, providing guidance for the development of orbitronic THz emitters.
Using a nonperturbative approach, the relaxation rate of orbital dipolar and quadrupolar moments is computed analytically for the t_{2g} states. In the presence of short-range impurities and in the absence of spin-orbit coupling, the orbital relaxation emerges from the competition between momentum scattering and the effect of the crystal field. In the case of weak disorder, the orbital relaxation time is proportional to the momentum scattering time: each scattering event contributes to destroying the orbital moment. In the case of strong disorder, the effect of the crystal field is averaged out, and the orbital relaxation time is inversely proportional to the momentum scattering. We finally find that the dipolar and quadrupolar orbital moments are coupled by the crystal field, resulting in a complex dynamical behavior upon orbital injection.
The conversion between spin and orbital currents is at the origin of the orbital torque and its Onsager reciprocal, the orbital pumping. Here, we propose a phenomenological model to describe the orbital torque in magnetic bilayers composed of an orbital source (i.e., a light metal such as Ti, Ru, CuO x , etc.) and a spin-orbit coupled magnet (i.e., typically Ni, (Co/Pt) n , etc.). This approach accounts for spin-to-orbit and orbit-to-spin conversion in the ferromagnet and at the interface. We show that the orbital torque arises from a compromise between orbital current injection from the orbital source to the ferromagnet and spin current backflow from the ferromagnet back to the orbital source. We also discuss the concept of orbital-mixing conductance and introduce the “orbit-spin-mixing” and “spin-orbit-mixing” conductances that govern the orbital torque and orbital pumping, respectively.
Magnetoelectric spin-orbit (MESO) logic, composed of a voltage-controlled magnetoelectric writing module and a spin-orbit readout module, is highly expected to substitute the silicon-based transistors and enable energy-efficient and scalable computing. Nevertheless, the output voltage of readout module based on spin-to-charge conversion is far less than the minimum magnetoelectric writing voltage, which greatly restricts the cascading function of MESO logic. Here, we first propose a magnetic tunnel junction (MTJ)-enhanced MESO logic to implement giant readout signal. Up to 1.5 mV output voltage is obtained, marking a significant improvement of approximately two orders of magnitude compared to previous findings. We ascribe the substantial enhancement to current modulation by junction resistance and the spin filtering effect of MgO-based MTJ. Moreover, the naturally integrated MTJ and MESO enables instantaneous and nonvolatile data exchange between computing module and external unit. Our work not only enhances output signal of readout module for direct cascading of MESO logic but also refines the design architecture, marking a pivotal stride forward in propelling MESO technology toward practical applications.
Ultra-fast magnetization switching triggered by a single femtosecond laser pulse has gained significant attention over the last decade for its potential in low-power consumption, high-speed memory applications. However, this phenomenon has been primarily observed in Gd-based ferrimagnetic materials, which are unsuitable for storage due to their weak perpendicular magnetic anisotropy (PMA). In this work, we demonstrated that applying a single laser pulse and an in-plane magnetic field can facilitate magnetic switching in a Pt/Co/Pt ferromagnetic trilayers stack within a specific laser power window. To further understand this phenomenon, we introduce a Cu layer to accelerate the re-establishment time of the anisotropy field of Pt/Co/Pt trilayers, which leads to bullseye-patterned magnetic switching. We have mapped phase diagram for these phenomena, and through micromagnetic simulations, we have determined that these switchings are influenced by thermal anisotropy torque, which can be modulated through PMA. These findings indicate that single-shot optical precessional magnetization reversal is feasible in a broader range of materials, opening avenues for the development of optical-magnetic memory devices.
The discovery of the orbital Hall effect (OHE) has established the orbital degree of freedom as a critical enabler for energy-efficient magnetic memory technologies. While massive materials have demonstrated the ability to produce giant OHE based on their unique orbital texture, a general method for realizing giant OHE in a CMOS-compatible material remains elusive. Here, we propose heavy-element doping of Cu base as a general strategy to boost OHE via sp,d -coupling-engineered orbital texture. We synthesize two sample series with Ni and CoFeB ferromagnetic layers on doped Cu base, i.e. , Cu 7 X 1 alloys (X = Ta, W, Tb, Mn) to separate OHE and spin Hall effect (SHE) contributions. Spin-torque ferromagnetic resonance measurements demonstrate that OHE-induced spin-orbital torque efficiency is enhanced approximately sixfold in Cu 7 X 1 alloys, comparable to heavy metal of Ta and W. Current-induced magnetization switching experiments confirm this enhancement, with a significant reduction in critical switching current density. Theoretical calculations reveal that the enhanced OHE originates from orbital coupling between Cu 4 s /4 p orbitals near the Fermi level and 5 d orbitals of dopant element with large orbital angular momentum. This work provides a general strategy to realize significant OHE in CMOS-compatible materials, enabling high-efficiency orbitronic applications.