Yang Yu

Yang Yu

Auto-generated profile, based on publicly available information

Yang Yu

Texas Tech University

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 August 2016 in SPE Reservoir Evaluation & Engineering
Verified
Journal Article
Closed access
PDF file
XMXingbang Meng
Xingbang Meng
JSJames J. J Sheng
James J. J Sheng
YYYang Yu
Yang Yu
Summary: This paper examines the potential of huff ’n’ puff gas-injection method to recover condensate in shale gas–condensate reservoirs by conducting experiments on a shale core. Numerical models were developed to verify experiment results. Our laboratory study shows that condensate recovery was increased to 25% by applying huff ’n’ puff gas injection on a shale core. Also, we compared the efficiency of huff ’n’ puff gas injection with that of gasflooding. At the end of same flooding with time that is the same as the time for five huff ’n’ puff cycles, the condensate recovery is 19%. From the experimental results, we found that huff ’n’ puff was more effective than gasflooding. During the experiment, condensate accumulated near the production-end region. In the huff ’n’ puff process, because the location for injection in the core was the same as that for production, the pressure in the condensate region built up faster than pressure in the flooding experiment. Also, because of the ultralow permeability, the pressure propagation was much slower in the shale core than in a conventional reservoir core, and the efficiency of gasflooding is much lower than that of the huff ’n’ puff.This study indicates that huff ’n’ puff has the potential to effectively enhance condensate recovery in shale gas–condensate reservoirs.

1 December 2015 in Journal of Unconventional Oil and Gas Resources
Verified
Journal Article
Closed access
TWTao Wan
Tao Wan
YYYang Yu
Yang Yu
JSJames J. J Sheng
James J. J Sheng

1 February 2017 in Journal of Natural Gas Science and Engineering
Verified
Journal Article
Closed access
YYYang Yu
Yang Yu
LLLei Li
Lei Li
JSJames J. J Sheng
James J. J Sheng

1 January 2017 in Journal of Petroleum Science and Engineering
Verified
Journal Article
Closed access
YYYang Yu
Yang Yu
JSJames J. Sheng
James J. Sheng

26 September 2016
Verified
Conference Paper
Closed access
PDF file
YYYang Yu
Yang Yu
LLLei Li
Lei Li
JSJames J. J Sheng
James J. J Sheng
Cyclic gas injection (CGI), also known as huff-n-puff process, has been demonstrated as the most effective and promising IOR solution in shale reservoirs. Such process involves many operating parameters that can affect the recovery performance in different degrees. As soaking time and pressure depletion rate (PDR) are the two crucial factors, this study aims to further investigate their roles in the oil recovery process of CGI experimentally and numerically. A total of ten series of the N2 huff-n-puff tests were performed on oil-saturated Eagle Ford shale plugs in a matrix-fracture system. With the injection pressure (Pin) of 1,000 psi, two groups of tests were conducted: 1) under a constant PDR in blowout and five soaking times changed from 0.25-hr to 48-hr; 2) under a constant soaking time of 12-hr and four pressure depletion times changed from 0.05-hr to 48-hr. With the Pin of 5,000 psi, the CGI tests were performed under 12-hr soaking time and blowout pressure depletion to study the effect of Pin on recovery efficiency. Lab-scale simulation models were built and tuned to history match the experimental data. The experimental results show that recovery factor (RF) from a single cycle increases with soaking time within a certain range, and a longer time has no effect on improving oil recovery. For 1,000 psi Pin, during the soaking phase, the system pressure declined rapidly at the first 3 hr and then became stabilized. The pressure drop was relatively low (10 psi) in the first cycle compared with the following cycles. It tended to increase with the number of cycles performed, which was caused by the decrease of oil saturation thus more gas can be injected into the core sample. It reveals that a soaking period is necessary to the oil recovery process. On the other hand, increasing the pressure depletion rate can raise the incremental RF from each cycle. The blowout condition showed the highest cumulative RF. The performance of N2 huff-n-puff with 5,000 psi Pin outperforms the case of 1,000 psi, which can increase the ultimate RF with less cycles. The well-tuned simulation models were used to analyze and optimize the CGI recovery process.

1 September 2016 in Journal of Unconventional Oil and Gas Resources
Verified
Journal Article
Closed access
YYYang Yu
Yang Yu
XMXingbang Meng
Xingbang Meng
JSJames J. J Sheng
James J. J Sheng