David P. Cann

David P. Cann

Auto-generated profile, based on publicly available information

David P. Cann

Oregon State University, Corvallis, USA

Research Focus & Metrics

Academic Career Length

31Years (1996-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2006 in Thin Solid Films
Verified
Journal Article
Closed access
MMMeagen A. Marquardt
Meagen A. Marquardt
NANathan A. Ashmore
Nathan A. Ashmore
DCDavid P. Cann
David P. Cann

1 November 1996 in Solid State Communications
Verified
Journal Article
Closed access
DCDavid P. Cann
David P. Cann
CRClive Randall
Clive Randall
TSThomas R. Shrout
Thomas R. Shrout

1 November 2004 in Journal of Applied Physics
Verified
Journal Article
Closed access
NVNaratip Vittayakorn
Naratip Vittayakorn
GRGobwute Rujijanagul
Gobwute Rujijanagul
XTXiaoli Tan
Xiaoli Tan
MMMeagen A. Marquardt
Meagen A. Marquardt
DCDavid P. Cann
David P. Cann
The solid solution between the normal ferroelectric Pb(Zr1∕2Ti1∕2)O3 (PZT) and relaxor ferroelectric Pb(Ni1∕3Nb2∕3)O3 (PNN) was synthesized by the columbite method. The phase structure and dielectric properties of xPZT-(1−x)PNN where x=0.4–0.9 and the Zr∕Ti composition was fixed close to the morphotropic phase boundary (MPB) were investigated. With these data, the ferroelectric phase diagram between PZT and PNN has been established. The relaxor ferroelectric nature of PNN gradually transformed towards a normal ferroelectric state towards the composition 0.7PZT-0.3PNN, in which the permittivity was characterized by a sharp peak and the disappearance of dispersive behavior. X-ray diffraction analysis demonstrated the coexistence of both the rhombohedral and tetragonal phases at the composition 0.8PZT-0.2PNN, a new morphotropic phase boundary within this system. Examination of the dielectric spectra indicates that PZT-PNN exhibits an extremely high relative permittivity near the MPB composition. The permittivity shows a shoulder at the rhombohedral to tetragonal phase transition temperature TRT=195°C , and then a maximum permittivity (36 000 at 10kHz ) at the transition temperature Tmax=277°C at the MPB composition. The maximum transition temperature of this system was 326°C at the composition x=0.9 with the relative permittivity of 32 000 at 10kHz .

15 July 2008 in Journal of Applied Physics
Verified
Journal Article
Closed access
CHChien-Chih Huang
Chien-Chih Huang
DCDavid P. Cann
David P. Cann
( 1 − x ) Bi ( Zn 1 / 2 Ti 1 / 2 ) O 3 − x BaTiO 3 polycrystalline ceramics were obtained via solid state processing techniques. The perovskite structure was found to be stable for compositions containing x=0.66 or greater. Based on x-ray diffraction data, a morphotropic phase boundary between tetragonal and rhombohedral perovskite phases was observed at x≈0.9. For compositions rich in BaTiO3, the symmetry of the perovskite phase was tetragonal but with increased Bi(Zn1/2Ti1/2)O3 content, the rhombohedral phase appeared. Dielectric characterization revealed that as Bi(Zn1/2Ti1/2)O3 content increased, the transition temperature decreased and the transition peak became very diffused. A comparison of the dielectric behavior with other Bi(Zn1/2Ti1/2)O3-based solid solutions is also discussed.

28 October 2005 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
EPEric A. Patterson
Eric A. Patterson
SKSeunghwa Kwon
Seunghwa Kwon
CHChien-Chih Huang
Chien-Chih Huang
DCDavid P. Cann
David P. Cann
The dielectric spectra of CaCu3Ti4O12 is characterized by a large permittivity (εr>10000) with only a weak dependence on temperature over the temperature range 200–400 K. In this work, doping with 0.1–1.0 wt % ZrO2 has been shown to dramatically reduce the dielectric loss. At 0.5 wt % ZrO2,tanδ remains below 0.05 over the frequency range 50 Hz–30 kHz and is just 0.065 at 100 kHz. While there is some diminution of the permittivity (εr≈5000 at 10 kHz) Zr-doped ceramics, exhibited very little bias dependence (ΔC∕C0<1.0% up to 40 V). In summary, results suggest that ZrO2 doping is an effective method for maintaining a high permittivity and low loss over a broad range in temperature, bias, and frequency.

9 July 2012 in Journal of the American Ceramic Society
Verified
Journal Article
Closed access
PDF file
NRNatthaphon Raengthon
Natthaphon Raengthon
TSTutu Sebastian
Tutu Sebastian
DCDenis Cumming
Denis Cumming
Ian M ReaneyIan M Reaney
Ian M Reaney
DCDavid P. Cann
David P. Cann