9 September 2020 in IEEE Transactions on Electron Devices
In this work, we demonstrate suspended two- and four-terminal field emission devices for high-temperature operation. The planar structures were fabricated with tungsten on a 200-nm silicon nitride membrane. The insulator in the vicinity of the terminals was removed to minimize undesirable Frenkel-Poole emission and increase the resistance of leakage current pathways. The effects of temperatures up to 450 °C on Fowler-Nordheim emission characteristics and parasitic leakage resistance were studied. Turn-on voltages with magnitudes under 15 V that further decreased as a function of increasing temperature for the two-terminal device were reported. Gating at temperatures of 150 °C and 300 °C was shown for the four-terminal device, and corresponding transconductance and cutoff frequency values were computed.
3 July 2023 in Applied Physics Letters
Nanoscale field emission devices are promising candidates to design high-frequency electronics due to the lack of scattering in the vacuum channel that enables ballistic transport. In-plane devices are relatively easy to fabricate with current fabrication techniques and offer sub-fF capacitance. In this work, the characteristics of lateral gold multi-tip field emission arrays are studied. Vacuum gaps between the electrodes of 30 nm are fabricated, which allow < 10 V operation. The effect of number of emitting tips on measured current is investigated. By taking advantage of the strong non-linearity in the emission characteristic, frequency mixing in the MHz range is also demonstrated.
31 May 2023 in Journal of Vacuum Science & Technology B
Although field emission devices are inherently robust to high temperature and radiation environments as well as have high switching speeds, their development has been hindered by high voltages that are typically required for their operation. In this work, we investigate the effect of thin-film praseodymium (Pr) coating on the emission characteristics of a lateral gold (Au) field emitter array. Because Pr has a significantly lower work function than Au, it is expected to increase the field emission measured current. Pr is deposited onto the device via thermal angled evaporation in a custom-built vacuum chamber with in situ electrical characterization capability. Our experiments demonstrate that a 10 nm-thick Pr layer reduces the turn-on voltage by almost half compared to the noncoated Au structure. These results are promising for the development of power-efficient, low voltage field emission electronics.